Charging Cart
Operation Guide
PW-CS30USB
Products Details
1. USB Power Strip
2. USB Charge & Sync Box
3. On/Off Button & Sync Port
Instruction (Charging)
1. Open the rear door and connect one end of the USB charging cable to the USB
power strip of the back panel
2. Through the hole of the back panel, extend the USB charging cable into the front
compartment charging area.
3. Open the front door and wrap the charging cable around the plastic baffle cable tray;
4. Connect the device that needs to be charged, turn on the power, and start charging.
Instruction (Synchronization)
1. The wiring of the device’s back panel is shown as below. Please use Port 1 for the
connection with computer to synchronize devices. A software for synchronization
management is also provide, which can be downloaded from our website.
2. If the device cannot to synchronize 30 devices at the same time, it might due to the
USB protocol of your computer which is not compatible. To solve this issue, we have
installed another two black cables which are connected to port 2 and port 3,
respectively. Please unplug the brown cables and plug the black cables in, so that
the computer can synchronize the devices in three batches separately.
Specification
1. Adopt the latest smart charging simulation mode to automatically identify all
mainstream USB charging devices to ensure fast charging. The built-in three
charging simulation profiles correspond to the three major charging protocols:
BC1.2 DCP charging protocol, Apple charging protocol, Samsung TAB charging
protocol. Adopt polling mode and high-precision current monitoring function
to ensure correct identification of the charging protocol of the corresponding
charging device;
2. Current monitoring: built-in high-precision current monitoring, real-time
monitoring of the charging current of each port;
3. Supports overcurrent protection. When the externally charged device or USB
cable is abnormally short-circuited, the abnormal port will automatically turn
off the cut-off voltage output, which will not affect the charging of other
normal ports.
4. LED light status indication:
• During charging---Red light flashes (the frequency of flashing gradually
decreases with the charging time);
• Charging completed - Green light;
• Synchronization---Red and green double lights are on at the same time.
/