One Stop Gardens 93579 Assembly And Operating Instructions Manual

Brand: One Stop Gardens

Model: 93579

Type: Assembly And Operating Instructions Manual

Thermometer / SolarThermometer / Solar

Thermometer / Solar

Garden LightGarden Light

Garden Light

ASSEMBLY AND OPERATING INSTRUCTIONS

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our Web site at http://www.harborfreight.com

manual or any artwork contained herein may be reproduced in any shape or form

without the express written consent of Harbor Freight Tools.

For technical questions and replacement parts, please call 1-800-444-3353

93579

Due to continuing improvements, actual product may differ slightly from the product described herein.

SKU 93579

For technical questions please call 1-800-444-3353

Page 2

Specifications

Save This Manual

You will need the manual for the safety warnings and precautions, assembly

instructions, operating and maintenance procedures, parts list and diagram. Keep

your invoice with this manual. Write the invoice number on the inside of the front

cover. Keep the manual and invoice in a safe and dry place for future reference.

Safety Warnings and Precautions

WARNING: When using tool, basic safety precautions should always be fol-

lowed to reduce the risk of personal injury and damage to equipment.

Read all instructions before using this tool!

1. Keep work area clean. Cluttered areas invite injuries.

2. Keep children away. This is not a toy. Children may injure themselves or

others if allowed to play with this item.

3. Do not overreach. Keep proper footing and balance when installing or

maintaining this item.

4. Maintain item with care. This item must be kept clean, dry, and free from

oil and grease at all times. Do not allow it to become fully immersed in water.

5. Disconnect power. Light may be manually turned off when not in use.

6. Stay alert. Watch what you are doing, use common sense. Do not install,

remove or adjust this item when you are tired or distracted.

7. Check for damaged parts. Before using any item, any part that appears

damaged should be carefully checked to determine that it will operate properly

and perform its intended function. Check for broken parts or mounting fixtures;

and any other condition that may affect proper operation. Any part that is

damaged should be properly repaired or replaced by a qualified technician. Do

not use the item if any switch does not turn On and Off properly.

:noitcurtsnoC

noitcurtsnoccitsalpomrehT

sekatsdnuorglatemruofhtiw

erutarepmeT

:egnaR

.F°021ot04-

.C°05ot04-

:rewoP

htiwlenaPraloSsuohpromA

HAm006V2.1AAdaCiN

yrettaBelbaegrahceR

:hctiwSrewoP

dnaFFO/NOedilSlaunaM

ffOo

tuAlleCotohP

llarevO

:snoisnemiD

.aiD"½-5xH"04:thgieWteN.sbL7.2

SKU 93579

For technical questions please call 1-800-444-3353

Page 3

8. Guard against electric shock. Prevent body contact with grounded surfaces

such as pipes, radiators, ranges, and refrigerator enclosures.

9. Replacement parts and accessories. When servicing, use only identical

replacement parts. Use of any other parts will void the warranty. Approved

parts are available from Harbor Freight Tools.

10. Do not operate the item if under the influence of alcohol or drugs. Read

warning labels on prescriptions to determine if your judgment or reflexes are

impaired while taking drugs. If there is any doubt, do not operate the tool.

11. Maintenance. For your safety, service and maintenance should be performed

regularly by a qualified technician.

12. Do not suspend this item. If this item should fall, the heavy metal legs could

cause severe personal or property injury. Only use this item firmly positioned

on the ground.

13. Wear personal safety equipment. When assembling and installing this

item, always wear safety gloves and ANSI approved safety goggles. Item has

pointed steel Ground Stakes and glass components which may cause injury if

not properly handled.

14. Always dispose of used batteris properly. Never throw a used battery into a

fire. Contact your local hazardous waste authority for proper battery disposal

guidelines.

Warning: The warnings, cautions, and instructions discussed in this instruction

manual cannot cover all possible conditions and situations that may occur. It

must be understood by the operator that common sense and caution are fac-

tors which cannot be built into this product, but must be supplied by the opera-

tor.

Unpacking

When unpacking, check to make sure that the product is intact and undamaged.

Be sure that the Ground Stakes are included.

If any parts are missing or broken, please call Harbor Freight Tools at the number

on the cover of this manual.

SKU 93579

For technical questions please call 1-800-444-3353

Page 4

Installation and Operation

This item utilizes the power of the Sun to provide light. During daylight hours,

solar energy is converted into electricity by the Solar Panel on top of the item. This

electrical energy is stored in the AA NiCad battery. The stored energy powers the

light.

The Thermometer operates continuously, and requires no outside power.

1. The Ground Stakes must be

installed. Slide each of the 4

Ground Stakes into the grooves

molded in the base of the

Thermometer. Be sure they are

all the way into the grooves and

the tab at the bottom of each

Stake catches the edge of the

base.

2. Open the Battery Case, and

remove the insulating tab from the

Battery. See page 5 for instructions on opening the Battery Case.

3. Select a location where the Thermometer will be easily visible, but will be out

of the way of traffic. This location must be on ground soft enough to embed the

Ground Stakes. There must be sufficient sunlight at this location during the

day to power the solar cell. CAUTION: Always wear safety gloves and ANSI

approved safety goggles when installing this item. Glass components may

break causing injury.

4. It may be necessary to soften the earth where the Thermometer will be installed.

5. Press the Ground Stakes straight down into the earth, keeping the Thermometer

in a full upright position, with the face of the thermometer facing the desired

direction.

6. Tamp the earth down around the Ground Stakes to fix the Thermometer firmly in

position.

7. If you want the light to come on at night, move the Slide Switch to the ON position.

If you do not want the light to come on, move the Slide Switch to the OFF

position.

8. A photo Cell on the top of the item will prevent the light from illuminating during

the day. When it becomes dark, this cell will signal the light to turn on, if the

Slide Switch is in the ON position.

Installing the Ground Stakes

SKU 93579

For technical questions please call 1-800-444-3353

Page 5

Maintenance

CAUTION: Both the Solar Cell and the Thermometer are made of glass. Either

one can be damaged or broken if this item is knocked over or struck by some

object, such as a lawn mower. Protect this item from damage.

1. The Solar Cell must be kept clean to effectively gather solar energy.

Periodically wipe the surface with a damp cloth.

2. Do not allow any strong chemicals to contact this item. Wrap it or remove it if

you will be spraying the area where it is installed.

Trouble Shooting

1. The light won’t come on. Possible

causes include insufficient sunlight reaching

the Solar Cell, Slide Switch damaged or in

the OFF position, damaged Battery or LED

light. Solution: Clean the Solar Cell and

expose the item to strong sunlight for a full

day. Ensure that the Slide Switch is in the

ON position. Ensure that the storage tab

has been removed from the Battery.

Replace the NiCad battery. If the light still

won’t operate, take the item to a qualified

service technician for repair.

NOTE: To open the Battery Case, remove

the phillips head screw mounted on each

side of the item, under the Solar Cell. To

replace the battery, pull it straight out from its mounting bracket. To install new

battery, press it into the mounting

bracket, being sure to match the

polarity of the battery with the

markings in the battery compartment.

2. The light operates, but very

weakly. Possible causes include

insufficient sunlight reaching the Solar

Cell, dirty Solar Cell, and storage

Battery failure. Solution: Clean the

surface of the Solar Cell and expose to

strong sunlight for a full day. If the light

still operates weakly, replace the

NiCad battery. If the light still doesn’t

operate correctly, take the item to a

qualified service technician for repair.

Opening the Battery Case

The NiCad Storage Battery

SKU 93579

For technical questions please call 1-800-444-3353

Page 6

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM

IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR

DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE

BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR

THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT,

THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS

AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND

LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK

AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT

OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION

OF REPLACEMENT PARTS THERETO.

NOTE: Some parts are listed and shown for illustration purposes only and are not

available individually as replacement parts.

Solar Cell

Slide ON / OFF Switch

Light

Thermometer

Ground Stakes

(set of 4)

One Stop Gardens 93579 Assembly And Operating Instructions Manual

One Stop Gardens 93579 Assembly And Operating Instructions Manual

One Stop Gardens 93579 Assembly And Operating Instructions Manual

Related papers

Other documents