Microdia SDHC Operating instructions

Type
Operating instructions

This manual is also suitable for

SD
TM
& SDHC
TM
MEMORY
CARDS OPERATING MANUAL
SPECIFICATIONS
CONFIRMATION OF PARTS LIST
Dimension: 24.0 (W) x 32.0 (L) x 2.1 (T) mm
Weight: Approx. 2g
Voltage Performance: 2.7 to 3.6 V
Temperature Performance:
-40°C to +85°C
Clock Frequency: Up to 25MB/sec
Humidity Performance: 5% to 95% RH
Plastic Case Manual
SD
TM
or SDHC
TM
Memory card
NOTE: Specifications are subject to change without notice.
REMOVAL THE PLASTIC CASE FROM BLISTER
1. Hold tight of the blister.
2. Hold the blister upside down with about an inch of distance between the blister and the table.
3. Use your fingers to push the edge of the plastic case.
4. Then plastic case with SD
TM
/ SDHC
TM
card will drop on the table
Step 1
(SD
TM
Memory Card)
Step 1
(SDHC
TM
Memory Card)
Step 2 & Step 3
Step 4
(SD
TM
Memory Card)
Step 4
(SDHC
TM
Memory Card)
REMOVAL AND STORAGE OF THE SD
TM
OR SDHC
TM
CARD IN PLASTIC CASE
1. Hold the plastic case tight when opening and closing.
2. Unlock and open the lid of the case.
3. Store or remove the SD
TM
/ SDHC
TM
card in the tray. Ensure the card is placed properly on the tray before closing the
case.
4. And then lock the plastic case.
Step 1 (SD
TM
Memory Card) Step 1 (SDHC
TM
Memory Card) Step 3 (SD
TM
Memory Card)
Step 3
(SDHC
TM
Memory Card)
MICRODIA (USA)
Camden Ave., San Jose, CA 95120, USA
MICRODIA (UK)
Brickhill Drive, Manton Height, Bedford,
MK41 7QH, England
MICRODIA (HONG KONG)
International Sales Office
1371, HITEC, Trademart Drive, Kowloon Bay, Hong Kong
Tel: +852.2801.7813 Fax: +852.2801.7060
Website:
http://www.microdia.com
Email:
sales@microdia.com
PRECAUTIONS FOR HANDLING AND STORAGE
Keep out of the reach of children. Get medical advice immediately if swallowed.
Do not touch the interface pin directly by hands, metal or hard objects.
Do not modify or disassemble the SD
TM
/ SDHC
TM
card.
Do not wet, heat/fire, impact, drop or bend the SD
TM
/ SDHC
TM
card.
Do not use or store in a humid and dusty place; in hot place such as inside a hot car, under a blazing
sun, near fire, a stove, an air-conditioner outlet, etc.
Do not expose to strong magnet fields, electrical noise and put near corrosive chemicals/gas. This may
cause damage through melting or the emission of heat/smoke or cause product failure.
Do not place in cooking appliances such as microwave ovens or high-pressure containers.
Do not detach the label on the SD
TM
/ SDHC
TM
card. Do not attach other stickers/labels on the SD
TM
/
SDHC
TM
card.
DATA PROTECTION
MICRODIA SD
TM
/ SDHC
TM
Memory Card comes pre-formatted. Make sure to back up all the data on
your SD
TM
/ SDHC
TM
card before formatting.
Slide down Write-Protect Switch to “LOCK” for preventing record/edit the card. Unlock the card
before reading/writing data.
Unlock
Lock
Do not remove the SD
TM
/ SDHC
TM
card and switch off any equipment using the card when data is
being read, written and transferred. It can cause data to be destroyed.
Insert the SD
TM
/ SDHC
TM
card firmly in the correct orientation. The product will not operate
correctly if it is inserted in an incorrect orientation or not inserted all the way
Parental Guidance is needed when a child uses the SD
TM
/ SDHC
TM
card. Teach the child how to use
and protect the product and insure that the child follows your instructions.
  • Page 1 1
  • Page 2 2

Microdia SDHC Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI