Receiver Antenna
Bend the receiver antenna as shown below.
< >
< Only for 27MHz >
Before beginning assembly, please read these instructions thoroughly.
MZN110-T01
R
THE FINEST RADIO CONTROL MODELS
INSTRUCTION SHEET
No.MZN110
90mm
Narrow
Tools : Must be prepared.
*Cutter Knife. *Nippers *Adhesive for plastic
*A Phillips Screwdriver
(Precision type or a small sized)
+ +
VeilSide S2000 Millennium
For MINI-Z Racer MR-03N RM Type / MR-015 RM Type
White Body Set (Non Decoration)
2
For painting. use plastic model paints.
Attach each part as required.
Painting should be done before assembling.
Rear Mount Type (RM Type)
2x5mm
Front body mount.
Chassis
Caution : Do not screw-in
excessively.
Wheelbase (M)
1
Preparation of Chassis
Assemble the chassis as shown below.
Motor mounting position
Adjustment of Wheelbase / Front Tread
Wind Shield
Body
Side Body Mount (L)
Side Body Mount (R)
2
2 x 5mm
TP Screw
Replace the front body mount
with the one included in the set.
Front Body Mount
TP
23.5mm
2x6mm
2mm
Receiver Antenna
Antenna Cord
Caution : Do not screw-in
excessively.