2. Hi-Lift
  3. Jack Adjustable Tube Mount

Hi-Lift Jack Adjustable Tube Mount Installation guide

  • Hello! I have reviewed the provided installation instructions for the Hi-Lift Tube Mount TM-700. This mount is designed to attach Hi-Lift jacks to various round or square tubing structures. The document describes its features and how to install it. I am ready to answer your questions about the product.
  • What size tubing is this mount compatible with?
    What materials is the mount made of?
    Do I need to drill to install the mount?
TUBE MOUNT
ADJUSTABLE FOR
1” - 2” DIAMETER TUBING
Mount your Hi-Lift® jack to round or
square tube bumpers, bull bars, roll cages,
and roof racks.
Manufactured of 6061-T6 structural alumi-
num with stainless steel hardware. No
drilling!
TUBE MOUNT
ADJUSTABLE FOR
1” - 2” DIAMETER TUBING
Hi-Lift Jack Company
P.O. Box 228
Bloomfield, IN 47424
Toll Free (800) 233-2051
Direct (812) 384-4441
www.hi-lift.com
UPC CODE
Part #TM-700
EACH UNIT INCLUDES:
2 ea. Aluminum Brackets
2 ea. Aluminum Knobs
2 ea. Long “V” Bolts
2 ea. Short “V” Bolts
4 ea. 5/16” Hex Nuts
4 ea. 5/16” Flat Washers
4 ea. 5/16” Lock Washers
2 ea. 1/2” Lock Washers
(Secure Brackets as shown) (Secure Hi-Lift as shown)
INSTALLATION INSTRUCTIONS
Use Short “V” Bolts for 1” - 1-1/2” Tubing
Applications
Use Long “V” Bolts for 1-1/2” - 2” Tubing
Applications
Secure “V”” Bolts to Aluminum Brackets with
5/16” Flat Washer, then 5/16” Lock Washer,
and 5/16” Hex Nut.
Fully tighten hardware once the Tube Mount
locations are adjusted correctly.
Place Hi-Lift jack on Tube Mount
Assembly with Tube Mount Bolts
through holes on the Steel Jack Bar.
Secure tightly with 1/2” Lock Washer
and Aluminum Knob.
/