PLANNING
GUIDE
www.Dacor.com
Phone: (800) 793-0093
Specications are subject to change without notice.
See installation instructions for additional details.
CI.17
Slide-In Cooktop/
Warming Drawers Stacked
COMBINATION INSTALLATIONS
Dacor Models
(A) Cabinet Cutout
Width
(B) Min.
Cabinet Width
(C) Cutout
Height
(D) Min. Gap
Between Cutouts
24 Inch wide models 22 1/2” (572 mm) 24 1/4” (616 mm)
9 1/8” (232 mm) 1 1/4” (32 mm)
27 Inch wide models 25 1/2” (648 mm) 27 1/4” (692 mm)
30 Inch wide models 28 1/2 (724 mm) 30 1/4” (768 mm)
NOTES:
24” (610 mm) minimum interior cabinet depth.1.
3/4” (19 mm) support platform (flush with cutout).2.
Spacing may vary for warming drawers with a custom 3.
front panel. See warming drawer installation instructions
for further details.
See individual planning guide pages to determine 4.
overlays.
IWD, OWD and 36 Inch series models cannot be installed 5.
above or below another warming drawer (any type).
Spacing between appliances and doors/drawers 6.
is minimum required to allow for ventilation and to
prevent scraping. Additional space may be required for
appearance.
A
Warming drawer
Slide-in gas cooktops
B
Cooktop platform
1” (25 mm) Min.
thickness
D
3/4"
(19 mm) Min.
120 Vac
electrical
output
Warming drawer
7 3/4" (197 mm)
C
C
DRT/EG SERIES COOKTOP WITH WARMING DRAWERS
(STACKED INSTALLATION)
All tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated
WARNING
Observe all governing codes and ordinances during •
planning and installation. Contact your local building
department for further information.
All appliances must be installed in accordance with the •
accompanying installation instructions.
1, 2
3, 6
3, 6
3, 6
1, 2
Document # PGCI - 012
Revised 11/19/09 Page 1/1
/