PLANNING
GUIDE
www.Dacor.com
Phone: (800) 793-0093
Specications are subject to change without notice.
See installation instructions for additional details.
CI.18
Slide-In Cooktop/Warming Drawers
(Side-by-Side)
COMBINATION INSTALLATIONS
Dacor Models
(A) Cabinet Cutout
Width
(B) Minimum Gap
Between Cutouts
(C) Minimum
Width to Adjacent
Door/Drawers
(D) Cutout Height
IWD24
EWD24
22 1/2” (572 mm) 1 3/4” (44 mm) 48 1/2” (1232 mm) 9 1/8” (232 mm)
OWD24 22 5/8” (575 mm) 1 3/4” (44 mm) 48 3/4” (1238 mm) 11 15/16” (303 mm)
NOTES:
24” (610 mm) minimum interior cabinet depth 1.
(20 1/8" for model OWD24).
3/4” (19 mm) support platform (flush with cutout).2.
Spacing may vary for warming drawers with a 3.
custom front panel. See warming drawer installation
instructions for further details.
See individual appliance planning guide pages for 4.
overlay dimensions.
Spacing between appliances and doors/drawers 5.
is minimum required to allow for ventilation and to
prevent scraping. Additional space may be required for
appearance.
DRT/EG SERIES COOKTOP WITH SIDE BY SIDE WARMING DRAWERS
Slide-in gas cooktop
Warming drawer
A A
C
120 Vac
electrical
outlet
36"
(914 mm)
Warming drawer
B
Cooktop platform
1” (25 mm) Min. thickness
7 3/4” (197 mm)
3/4” (19 mm)
D
All tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated
WARNING
Observe all governing codes and ordinances during •
planning and installation. Contact your local building
department for further information.
All appliances must be installed in accordance with the •
accompanying installation instructions.
1, 2
1, 2
3, 5
3, 5
3, 5
3, 5
Document # PGCI - 014
Revised 09/28/09 Page 1/1
