the steam nozzle.
– Position the jug underneath the steam
nozzle or milk frother in such a way that it
is just under the surface at all times.
– Turn the rotary control to the steam
symbol (
). e steam nozzle is now
open.
– A er a brief heating period, steam will be
emitted.
– Turn the jug with a circular motion for
around 40-45 seconds.
– Once the steam function is no longer
required, place a suitable container under
the steam nozzle and turn the rotary
control to the
position. Wait until
steam is no longer emitted.
General Care and Cleaning
Remove the plug from the wall socket and
wait until the appliance has cooled down.
– To clean the steam nozzle each time a er
use, place a suitable container underneath
it and turn the rotary control to the
position.
– Wipe o the milk frother with a damp
cloth once it has cooled down. It should
be frequently removed for thorough
cleaning; ensure, however, that the
appliance has su ciently cooled down
before the frother is removed and cleaned
with hot soapy water.
– To remove any remaining water from the
water container, wait until the appliance
has cooled down, remove all other
accessories and unscrew the lid. Pour out
the water through the water ll opening.
To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
Do not use abrasives or harsh cleaning
solutions.
– e exterior housing may be wiped with a
damp, lint-free cloth.
– e glass carafe, lter holder, lter insert
and drip tray may be cleaned in warm
water using a mild detergent; do not clean
these parts in a dish-washer.
Descaling instructions
Depending on the water quality (lime
content) in your area as well as the frequency
of use, all thermal household appliances using
hot water need descaling (i.e. removal of lime
deposits) on a regular basis to ensure proper
functioning. Any warranty claim will be
null and void if the appliance malfunctions
because of insu cient descaling.
When the brewing process takes longer than
normal, it is likely that descaling is necessary.
– Mix four cups of water with a
commercially available descaling solution
(follow the manufacturer’s information
for the right concentration).
– Pour the mixture into the water container.
– Let the appliance run through one or two
brewing cycles (as described in the section
Making espresso) with the lter holder
tted, but without using the lter insert
and without putting in any co ee.
– As soon as the glass carafe has half lled,
set the rotary switch to the
-symbol.
– Place a suitable container underneath the
steam nozzle and turn the rotary control
to the steam symbol (
). Activate the
steam nozzle for around 2 minutes.
– en set the rotary control to the
-symbol, and allow the descaling solution
to take e ect.
– A er approx. 15 minutes, turn the rotary
control back to the espresso symbol
(
) and allow the water container to
drain completely before turning the rotary
control to the
position (place a
suitable container underneath the steam
nozzle).
– To clean out the system a er descaling,
operate the appliance twice more with
clean water only, activating the steam
nozzle for approx 2 minutes a er each
cycle.
– Rinse the screw-in lid, lter holder and
glass carafe in clean water.
Do not pour descalers into enamelled
sinks.
12