Page is loading ...
INSTRUCTION MANUAL
WSM-5061VA
WARNING:
⋅ Installation by qualified personnel only.
⋅ Speakers must be wired in parallel and connected to
the correct line terminals of amplifier.
⋅ Ensure that all speakers have the same polarity with
respect to each other.
⋅ Do not select another tapings if the speaker is in use.
⋅ No naked flame sources, such as li
g
hted candles,
should be placed on the apparatus.
SPECIAL SPEAKER
SPECIFICATIONS
Step 1 – Dismantle the three screws on the side of the speaker.
Step 2 – Remove the upper cover.
Step 3 – Remove the two lateral metallic plates in order to let free the input and output cable holes.
Step 4 – Install speakers line through one of the holes and connect cables to IN+ and IN- of screw terminal.
Step 5 – Continue with the speaker line connection from OUT+ and OUT- using the remaining hole.
Model WSM-5061
Loudspeaker 5” bicone
Rated Power (RMS) 6 W
Power taps 100V 6 W, 3 W, 1’5 W & 0’75 W
Power taps 70 V 3 W, 1’5 W, 0’75 & 0’375 W
Impedance
1k7 Ω, 3k3 Ω, 6k7 Ω & 13k3 Ω
Sensitivity SPL (1 W / 1 m) 91 dB
Sound Pressure SPL (6 W / 1 m) 99 dB
Freq. Range 150 ~ 18.000 Hz
Dispersion 1 kHz / 4 kHz 165º / 70º
Dimension (mm) 163,5 x 163,5 x 60 (height)
Weight 2,1 kg
Finish Plain steel
Colour White (RAL 9010)
Mounting Screws
Certification BS-5839, part 8
Power selection Transformer taps
INSTALLATION GUIDE
/
