Too Cute Beads Crystal Cross Earring Kit Operating instructions

Crystal Cross Earring Kit

Take your artistic wire and cut them in half leaving you 2 equal lengths. Cut

each of those in half, setting 2 aside for your second earring.

Pinch one end of the wire with round nose pliers to curl the wire and create

your circle.

On the second piece of wire, make a loop with your round rose pliers in the

middle of the wire. This will be the horizontal length of the cross.

Go back to your ﬁrst wire (with loop end) and load the following

Bicone / Round / Bicone / Round / Bicone

Add your second artistic wire (Using the middle loop to stack on your

bicone).

Continue loading beads.

Bicone / Round / Bicone!

Use your round nose pliers to create a loop at the top of your beads, creating

the ﬁrst section of your cross.

We will now load the horizontal portion of the cross.!

Now we need to load our horizontal beads.!

Add a bicone, round and bicone to each side of the wire, and create a loop to

hold them in place.

Trim all excess wires.

Attach your ear wire, and repeat for your second earring.

For easy re-order, scan this QR code with your phone