LBL Lighting CH1030BZLED927 Installation guide

Type
Installation guide

This manual is also suitable for

1
Installation Instructions for
Malena Large Pendant
980MALNAP
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing
NEC compliant junction boxes.
This product is suitable for damp locations.
Incandescent lamps may be dimmed with a standard incandescent
dimmer. LED lamps may be dimmed with a LED dimmer. Consult
lamp manufacturer for additional information.
1.0
L 1071P
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Pendant
Install the mounting plate onto the electrical box with the two #8-32 screws provided.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage information.
Lower the shade into place over the socket.
Screw the lower strain relief on to the socket nipple.
Slide the canopy cap and canopy over the aircraft cable then push the aircraft cable into the cable grip on the mounting plate. adjust the
cable until the desired height is achieved.
Loosen the upper strain relief on the canopy to allow for adjusting the cord length and look. Mark in pencil on the cord at the bottom of
the strain relief to note the location of the canopy.
Connect the fixture to suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Properly place all wires and wire nut connections into the electrical box, mount the canopy onto the mounting plate by pushing the
canopy up to the ceiling and secure in place with the canopy cap.
Adjust the cord to the marked location if necessary and tighten the upper strain relief.
1
2
1A
Install the Fixture
3
4
5
6
7
8
9
10
2
3
4
11
9
8
7
1
6
10
4
5
CANOPY
CANOPY
CAP
LOWER
STRAIN RELIEF
#8-32 SCREW
CABLE GRIP
LAMP
SHADE
UPPER
STRAIN
RELIEF
11
2
SAVETHESE INSTRUCTIONS!
1
© 2018 Lighting.All rights reserved.The " Lighting" graphic is aLBL LBL
registered trademark of Lighting. Lighting reserves the right toLBL LBL
change specifications for product improvements without notification.
7400 Linder Ave, Skokie, 60077IL
800.323.3226 - 847.626.6300
www.lbllighting.com
A Generation Brands Company
  • Page 1 1
  • Page 2 2

LBL Lighting CH1030BZLED927 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI