hykolity Hykolity 2FT LED High Bay Shop Light,165W 22275lm 135LM/W [400W Equiv.} 5000K Daylight Linear Hanging Light for Warehouse, 4 Lamp Fluorescent Fixture Replacement, 1-10V Dim, UL, DLC Premium Complied Installation guide

Type
Installation guide
Installation Instruction
General Wiring Diagram
W
ARNING
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions,
and other hazards read all warnings and instructions included with and on the fixture box and all fixture labels.
Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
Commercial installation, service and maintenance of luminaires should be performed by a qualified licensed electrician.
For the installation: If you are unsure about the installation or maintenance of the luminaires, consult a qualified
licensed electrician and check your local electrical code.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
W
ARNING
Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
Turn off the power when you perform any maintenance.
Verify that supply voltage is correct by comparing it with the luminaire label information.
All wiring connections should be capped with UL approved wire connectors.
CA
UTION
Avoid direct eye exposure to the light source while it is on.
Account for small parts and destroy packing material, as these may be hazardous to children.
NO
TICE:
NOTICE:
Resk od burn. Disconnect power and allow fixture to cool befor changing bulb or handing fixture.
Green ground screw provided in proper location.Do not relocate.
Minimum 90° supply conductors.
NO
TICE:
Specifications and dimensions subject to change without notice.
NO
TICE:
Suitable for Dry or Damp location.
120-277v
Black(Line)
White(Neutral)
Green(Grd)
Purple(Dim+)
Grey(Dim-)
Blue(-)
Red(+)
Dimming wire
to 0-10v IEC
compliant control
Lead wire to
LED load
Installation Instruction
B:
Wire Guards
Chain Kit
A:
Installation Instruction
D:
Pendant Hanger
C:
Surface Mounting
For 3/8" IPS
Installation Step:
Remove the new LED fixture from packaging and inspect for any damages. Handle new LED fixture with care.
CHAIN MOUNT EXAMPLE; Install the chain into the provided wire hanger. Secure the other end of the chain to a
structure using hardware rated for the load.Install the wire hanger onto the side of the top ETLB7 LED channel.
Make sure the wiring hangers are fully engaged into the side holes on the top channel.
Connect the LED high bay wiring to line wire, black to black, white to white and green to green. Use only UL listed wiring.
**NOTE: Purple and grey lead inside the driver compartment are 0-10V (low voltage) dimming leads. Connect
to dimming low voltage wiring only.
Clean all residues/fingerprints from the new LED high bay and lens. Double check all hanging hardware before moving
onto the next installation.
Always turn off the power supply from main circuit breaker first!
  • Page 1 1
  • Page 2 2
  • Page 3 3

hykolity Hykolity 2FT LED High Bay Shop Light,165W 22275lm 135LM/W [400W Equiv.} 5000K Daylight Linear Hanging Light for Warehouse, 4 Lamp Fluorescent Fixture Replacement, 1-10V Dim, UL, DLC Premium Complied Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI