Grandeur 841262 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Grandeur 841262 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
USE INCLUDED DOOR PREPARATION
TEMPLATE FOR NON-PREPPED DOORS.
USE INCLUDED PLASTIC TEMPLATE TO
LOCATE AND DRILL THE TWO TALL PLATE 1/4”
MOUNTING HOLES. (See note on reverse side.)
1/4”
1/4”
Tall Plate
Mounting
Holes
14
14
2
2
13
13A
Install
deadbolt
and
entrance
latches.
Tongue
Entrance Latch
Tongue
(See D Below Before
Deadbolt Latch
Installation.)
(See Latch
Tongue
Note
in Panel C)
3/4”
3/4”
Latch Tongue
Note
Bevel Side
Face Plate Curve
Strike Plate Curve
Bevel side of latch tongue should
contact curved end of face plate,
and curved end of strike plate.
Deadbolt
Latch Tongue Note
Intall screw
extenders
into
exterior
tall
plate.
Tighten
securely.
Screw
Extenders
(part #8)
Door Outside
Install cylinder into
exterior tall plate.
Cylinder Assembly
(part #3)
Spin Ring (part #3c)
Door Outside
Door Inside Door Outside
3
5
Cylinder
Place exterior
tall plate on
door outside.
Attach
deadbolt
adaptor
plate with
provided
screws.
DO NOT
FULLY
TIGHTEN
THESE
SCREWS.
2”
6
Slide
exterior tall
plate up, hold,
and tighten
deadbolt
screws.
Check knob/lever
operation. Latch
tongue should
retract and extend
smoothly.
Attach interior
tall plate
with included
screws.
Check deadbolt
operation by
turning thumbturn
and key.
Check knob/lever
operation. Latch
tongue should
retract and extend
smoothly.
9
10
12
2
11
Install jamb strike plate.
Door
Jamb
3/4
Note: Entrance Tall Plates fit doors 1-3/4” to 2” thick.
Single Cylinder Tall Plate
TALL PLATE
ENTRANCE
Grandeur
Door Hardware
Installation Instructions
For assistance call 800-522-7336 Monday through Friday 7am to 5 pm Mountain Time
PK183 10062017
Latch
Deadbolt
Latch
Deadbolt
Tongue
Deadbolt
Face Plate
3/4” Flat Head
Wood Screws
Screw
Extender
Screw
Extender
1-1/2” Oval Head
Machine Screw
Latch
Tongue
Faceplate
Strike Plate
3/4” Flat Head
Wood Screws
Exploded Drawing for Tall Plate Entrance
Exterior Half of Lockset
Interior Half of Lockset
A
A
B
B
Push plastic templates large
circles (A) into existing bore
holes of door.
Use position of small holes (B)
to mark and drill 1/4” holes
through the door.
1.
2.
For assistance call 800-522-7336 Monday through Friday 7am to 5 pm Mountain Time
PK183 10062017
/