Instruction Manual XX237-10-00
Introduction
The information in this manual covers the installation of the V660-TRIM trim ring plate for the V660 Series of
Dome Cameras. This unit should be installed by a qualified technician using common hand tools and
approved materials and wiring methods in accordance with the national Electrical Code ANSI/NFPA 70, state
and local wiring codes. Read these instructions through completely before attempting installation.
The V660-TRIM provides the aesthetically pleasing mounting of the V660 Series Camera Domes (includes
V662V-312D, V662V-922D, V661V-312D, V661V-922D, V661V-312N, V661V-922N, V661V-312IR, V662D-
312D, V661D-312D, V661D-312N, V661D-312IR) to an existing 4 x 4 electrical box; using the trim plate
provides cover for the entire electrical box, leaving no open gaps.
Installation
When the V660 Series of Dome Cameras requires installation to a 4 x 4 electrical box with a neat look, the
V660-TRIM is required. Be sure the area in the selected location is clear of obstacles (such as steel beams,
headers, pipes, electrical wiring, etc.), which would interfere with mounting. Video and power cables must be
routed to the location. Refer to Installation and Operation Manual for the camera dome for detailed
information on the installation of the camera dome. Follow the steps below and refer to Figure 1 for an
outdoor dome and Figure 2 for an indoor dome.
1. Install the V660-TRIM onto an existing 4 x 4 electrical box using the two (2) flat head 8-32 screws
provided.
2. Route the cables through the electrical box/V660-TRIM assembly. Make electrical and video connections.
3. Secure the Camera Surface Mounting Ring (indoor dome)/Camera Base Housing (outdoor dome) to the
trim plate using the two (2) Phillips head 8-32 screws provided; on the outdoor dome, be sure to also use
the No. 8 flat washer. Be sure the side cable access hole on the outdoor dome is aligned with the notch
cutout on the trim plate for ease of cable installation.
4. In the indoor dome, insert the camera base housing into the camera surface mounting ring; be sure the
cable grommet on the camera base is aligned with the cable access hole in the mounting ring. Tighten
the screws on the camera base to secure the locking tabs.
Vicon part number 8009-8237-10-00
Copyright © 2011 Vicon Industries Inc. All rights reserved. Vicon and its logo are registered trademarks of Vicon Industries Inc.
Product specifications subject to change without notice.
VICON INDUSTRIES INC., 89 ARKAY DRIVE, HAUPPAUGE, NEW YORK 11788
TEL: 631-952-2288 FAX: 631-951-2288 TOLL FREE: 800-645-9116
24-Hour Technical Support: 800-34-VICON (800-348-4266)
UK: +44 (0) 1489 566300 WEB: www.vicon-security.com
