Page is loading ...
Page is loading ...
H
E
I II III
F
B
A
G
LIGHTING FUNCTIONS
SETTING THE TIME AND DATE
D
C
LIGHTING FUNCTIONS (g. 1)
Pusher:
E. Pusher
Lighting indications:
F. Blue LED light
G. White LED light
H. Red LED locator beacon
1. Dial illumination Mode: One quick
push of the pusher (E) activates the
soft blue LED light (F) for 6 seconds.
To deactivate, press the pusher (E)
once.
2. Extended Light Mode: Two quick
pushes of the pusher (E) activate the
white LED light (G).
3. Signal Mode: Three pushes of the
pusher (E) will cause the white LED
light to ash at 150 pulses/min. for
2 minutes.
Note: To deactivate Mode 2 / 3 prior to
2minutes, press the pusher (E) once.
4. SOS Signal Mode: Holding the
pusher (E) for 5 seconds will activate
an intensied SOS light signal.
Todeactivate, press the pusher (E)
for5seconds.
5. Locator Mode: Red LED locator
beacon (H) blinks once every 10
seconds. Five pushes of the pusher
(E) will deactivate the Locator
Mode. Five pushes of the pusher will
activate it again.
6. Battery End-of-Life Mode (EOL): Red
LED locator beacon (H) will ash 3
times every 10 seconds indicating the
lighting batteries should be changed.
SETTING THE TIME AND DATE (g. 2)
Timepiece indications:
A. Hours
B. Minutes
C. Seconds
D. Date
1. Pull out the crown to position III.
Theseconds hand (C) will stop.
2. Turn the crown to the desired time.
Remember the date advances at
12:00 midnight, not 12:00 noon.
3. Push the crown back to position I.
4. Pull out the crown to position II
(the watch continues to run).
5. Turn the crown clockwise to the
desired date.
6. Push the crown back into position I.
Note: To avoid any damage to the
movement, do not perform the DATE
SETTING between 9:00 p.m. and
3:00a.m. when the date mechanism
isin action.
Fig. 2
Fig. 1
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
