WE-43
Willow Edging Assembly
1-800-574-7248
www.mastergardenproducts.com
Unpack your Willow Edging and
it should look like the following
image:
1
Using the two stakes at the ends of the
item, push them into the area you decide to
put your Willow Edging. Only push your
Willow Edging into the ground if your soil is
soft and loose. If you have hard soil, we
would recommend getting a thin metal
stake, long screw driver, or any object thin
and long enough to put in, and hammer it
into the ground. This will create the two
holes you need in order to install the Wil-
low Edging.
2
3
If you are using multiple pieces of Willow
Edging, we would recommend using some
wire or a zip tie to secure the Willow Edg-
ing Stakes together. You may put the stake
next to the other Willow Edge piece into
the same hole as the other one. Always be
sure to backfill the holes together to secure
the Willow Edging. A picture description is
shown below. Zip ties and wires are not
included.
