The Murphy Door FMUNO30 Operating instructions

Type
Operating instructions

This manual is also suitable for

FLUSH MOUNT UNASSEMBLED KIT
ASSEMBLY INSTRUCTIONS
UPDATED & REVISED
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
Parts List
Countersunk Screw Holes
(8) 7x50mm Conrmat Screws
A
B
C
(6) #6 x 1.5in Square Head Pocket Screws
D
(12) Dowel Pins
E
F
B
(18) 8mm Wood Dowels
G
Jamb Side
Jamb Side
Jamb Top
Jamb Bottom
(Threshold)
JAMB
BOOKCASE
Back
Bookcase Side
Bookcase Side
Top
Bottom
Short Side
Middle
Top
Bottom
Short Side
Middle
Back Top
(Double Thick)
Back Middle
Adjustable Shelf Adjustable Shelf Adjustable Shelf
FACE FRAME
Top
Bottom
Long SideShort Side
Middle
Casing Side
Casing Side
Casing Top
Long Side
Long Side
Back Bottom
(Double Thick)
Bottom
Door Hinge
Bottom
Jamb Hinge
Top Door
Hinge
Top Jamb
Hinge
2 Notches
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
1
GLUE
X
NO GLUE
D
G
D
Pocket Screw
2
E
(
12
)
Make sure that all screw
placement holes for the
hinges are facing the top
side of the door.
The hinge pass-through
holes are the only thing
that should be visible
from the inside of the
bookshelf.
Dowel Hole
Dowel Hole
PLEASE READ INSTRUCTIONS FULLY BEFORE YOU BEGIN ASSEMBLY
The dowel holes where you will attach the face
frame are on the front side of each piece. Make
sure that they are all facing outward towards the
front of the door when assembling.
Top shelf will have pre-
drilled hole where you will
drop the hinge pin through.
The bottom shelf does not.
Top
Bottom
Long SideShort Side
Middle
Top
Bottom
Middle
Long Side
Short Side
Top
(Double Thick)
Middle
Bottom
(Double Thick)
Middle
Top
Bottom
Middle
Top
(Enlarged View)
NOTE: The top and bottom book-
shelf pieces are double thick and
the middle piece is just a standard
single thickness.
Assemble Face Frame
Assemble Bookcase
NOTE: Please verify dowel orientation to ensure that they are not installed upside down.
D
(
6
)
G
(
12
)
Dowel holes
toward top
Dowel holes
toward bottom
Dowel holes
toward top
Back
Back
Front
Front
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
C
(
12
)
Line up with middle (xed) shelf
4
3
Set Shelves
Top
Bottom
With the front of the bookcase laying at on the oor, use a rubber mallet and a small piece of wood to tap on each side
until it is ush with the front of the bookcase. This will ensure that the back piece is able to slide completely into place.
Note: The small piece of wood is used to prevent denting or damage to your shelves when setting in place.
The shelves should be ush with
the front of the bookcase when set
properly.
It is recommended that you use two people when placing the back to ensure that it slides
in straight to prevent it from getting wedged from sliding in crooked.
Place Back
Gently push on bookcase frame to square
before fastening the back with screws. Make
sure that the back is ush all the way across
the top and bottom.
Top
Bottom
Long Side
Short Side
Long Side
Short Side
VIEW OF
BACK OF DOOR
Back
Back
Back
Front
Front
Front
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
7
G
(
6
)
A
(
8
)
NOTE: Although not
required, you may use some
small nish nails in addition
to the glue to help secure
the face frame.
6
Fastening Face Frame
Assemble Jamb
Make sure that all dowel
holes are facing the front of
the door.
Long Side
Short Side
Top
Bottom
The Jamb Bottom (Threshold) is
wider than the rest of the jamb.
Make sure that it is ush with
the front and extends out the
back side.
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
8
Out-Swing Hinges
Front
Top of Door
Front
Top of Door
Front
Jamb Bottom
(Threshold)
Front
Jamb Bottom
(Threshold)
B B
B
B
These extra pre-drilled holes are only used for in-swing hinge conguration.
These extra pre-drilled holes are only used for in-swing hinge conguration.
OUT-SWING OUT-SWING
LEFT HINGE RIGHT HINGE
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
8
In-Swing Hinges
Front
Top of Door
Front
Top of Door
Front
Jamb Bottom
(Threshold)
Front
Jamb Bottom
(Threshold)
Pre-drilled pattern with hinge pin pass-through hole are only used for out-swing hinge conguration.
BB
B B
IN-SWING IN-SWING
These extra pre-drilled holes are only used for out-swing hinge conguration.
LEFT HINGE RIGHT HINGE
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
OUT SWING
IN SWING
DOOR SIDE
DOOR BACK
DOOR FRONT / FACE FRAME
VIEW OF
DOOR
BOTTOM
DOOR BOTTOM
LEFT HINGE
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
OUT SWING
IN SWING
DOOR SIDE
VIEW OF
DOOR
BOTTOM
DOOR BACK
DOOR FRONT / FACE FRAME
DOOR BOTTOM
RIGHT HINGE
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
4”
UPPER JAMB & LOWER THRESHOLD
HINGE TEMPLATE
LEFT HAND
PLACE IN FRONT CORNER
IN SWING
OUT SWING
NOTE: Some holes will extend
over the edge when placing
on the Upper Jamb.
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
UPPER JAMB & LOWER THRESHOLD
HINGE TEMPLATE
RIGHT HAND
PLACE IN FRONT CORNER
IN SWING
OUT SWING
4”
NOTE: Some holes will extend
over the edge when placing
on the Upper Jamb.
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
Ogden Headquarters
3754 Pacic Ave
Ogden, UT 84405
Kentucky Distribution
Center & Showroom
2320 Fortune Dr. #180
Lexington, KY 40509
MurphyDoor.com888-458-5911 FMAM-1.7-20161004
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

The Murphy Door FMUNO30 Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI