Polycom IPOWER 9000 Support Manual

Brand: Polycom

Model: IPOWER 9000

Type: Support Manual

Polycom and the Polycom logo are registered trademarks of Polycom, Inc.

iPower is a trademark of Polycom, Inc.

VISCA is a trademark of Sony Corporation.

Edition: 3725-50564-001/A

*P3725-50564-001*

Support for

VISCA-compatible Cameras

The Polycom

iPower

™

9000 system provides support for the VISCA

™

command

protocol. This capability allows users to control VISCA-compatible cameras from the

iPower system interface.

Supported

Cameras

The following VISCA-compatible cameras have been tested and support the controls

listed in the section “Supported Functionality.”

❑ Sony EVI-D30

❑ Sony EVI-D31

❑ Sony EVI-D100

❑ Sony EVI-D101

To connect the camera to the iPower system, use the control cable adapter (part

number 1457-50527-001). To order this cable, contact Polycom and request order

number 2200-51000-001.

Supported

Functionality

VISCA-compatible cameras support the following iPower camera controls:

❑ Pan

❑ Tilt

❑ Zoom

❑ Brightness

❑ Presets

Restrictions

Note the following restrictions when using VISCA-compatible camera with the

iPower 9000 system:

❑ Hardware Diagnostics does not detect the Sony D30 and D100 cameras. You

cannot test these cameras using Hardware Diagnostics.

❑ Daisy-chaining of cameras is not supported.

❑ If you configure a Pan, Tilt, or Zoom preset for a Sony D30 camera for the

minimum or maximum positional setting, the preset may not work reliably.

Additional

Information

For the latest information and updates, use your Web browser to go to the Polycom

Web site,

www.polycom.com.

Polycom IPOWER 9000 Support Manual

Polycom IPOWER 9000 Support Manual

Polycom IPOWER 9000 Support Manual

Related papers

Other documents