2. Elo
  3. E353758 mPOS Flip Stand

Elo E353758 mPOS Flip Stand User manual

  • Hello! I'm an AI assistant that has carefully reviewed the Installation Instructions for the Elo mPOS Printer Stand models E353758 and E949536. This document covers the complete assembly process, from removing the tray to attaching the optional rear-facing monitor, and provides all necessary details for a smooth installation. I'm ready to answer your questions about this printer stand.
  • How do I remove the printer tray?
    Where should cables be routed?
    What screws are used to attach 15i/10i?
Pg.1
QIG600035 Rev. D
1- Remove (2) screws (L &
R side) and pull-out printer
tray. Keep screws for re-
assembly.
2- Place Expansion Module
into base.
3–Route cables behind L
& R sides of stand plate.
Secure cables to stand with
tie-wraps; white band on
cables indicates correct
location to secure cables.
Attach points
for tie-wraps.
Stand plate
INSTALLATION INSTRUCTIONS:
E353758 / E949536 mPOS PRINTER STAND WITH
EXPANSION MODULE FOR ANDROID
Pg.2
4 -Re-assemble printer tray using
(2) screws, L & R side.
M4X6L
Screws, X4
5 - Attach 15i/10i using (4) M4X6L
screws. Plug in USB and PWR. cables,
attach cable doors.
Cable doors,
L &R.
6 - Insert compatible
printer.
(If adding optional
rear-facing touch
monitor ET1002L, go
to step 7before
installing printer).
QIG600035 Rev. D
INSTALLATION INSTRUCTIONS:
E353758 / E949536 mPOS PRINTER STAND WITH
EXPANSION MODULE FOR ANDROID
Optional rear-facing
monitor 1002L:
Pg.3
7- Remove (3)
plastic covers.
8 –Add (2) M4X8L Screws (provided with
stand) to 1002. Leave gap under screw
heads to allow 1002 to slide onto key
holes on stand back.
9 –Route cables through
clip on 1002 and through
hole in stand.
QIG600035 Rev. D
INSTALLATION INSTRUCTIONS:
E353758 / E949536 mPOS PRINTER STAND WITH
EXPANSION MODULE FOR ANDROID
1 –Remove the rubber before
assembling the cover.
2 –Use (2) M4x8 screws to attach
the cover to the VESA plate.
3 –Remove the protective film from
the included mylar covers and place
the covers over the screws.
NOTE –VESA Plate Cover is optional for the assembly, it will not
affect the function and performance.
QIG600035 Rev. D Pg.4
INSTALLATION INSTRUCTIONS:
E353758 / E949536 mPOS PRINTER STAND WITH
EXPANSION MODULE FOR ANDROID
VESA Plate Cover Assembly for E949536 (Optional)
/