2. Holtek
  3. Preliminary BC3603 PER-Demo
Preliminary BC3603 PER-Demo

Holtek Preliminary BC3603 PER-Demo User manual

  • Hello! I've reviewed the provided operation manual for the BC PER-Demo boards, specifically the BCE-GENTRX32-002 and BCT-3603-X01 models. This manual covers the hardware, power-on procedures, and the start of PER-Master and PER-Slaver functions. The device communication parameters such as transmission and reception values are also mentioned. I'm ready to address any questions regarding this device.
  • How do I start the PER-Slaver function?
    How do I start the PER-Master function?
    What does the LCM display after the function startup?
Preliminary
Page 1
BC3603 PER-Demo Operation Manual
Hardware Introduction
Terminal of master is made up of BCE-GENTRX32-002 and BCT-3603-X01
Picture.1 hardware of master
Terminal of slaver is made up of BCE-GENTRX32-002 and BCT-3603-X01
Picture.2 hardware of slaver
Preliminary
Page 2
Software
This operation manual is used with the following demo codes:
Picture.3 demo code files
Power On Procedure
1. At first, please select power supply mode from “Power Source”.
2. Connect the power supply interface.(For example by using USB interface)
3. Slide the main power switch.
Picture.4 power on procedure
Power-on State
After the demo board is powered on:
1. The Power LED will be steady work.
2. The LCM will display some parameter values, such as TX values, RX
values and ERROR values.
Tx: count value of RF successfully transmit
Ls: count value of RF failed transmit
Rx: count value of RF successfully receive
Er: count value of RF failed receive
Rsii: count value of RF RSSI detected when RF receive
(1)
(3)
(2)
Preliminary
Page 3
Operation procedure
1、 Press any button (key1~4) on the slaver board to start PER-Slaver function.
After the function startup is successful, LCM will display “ON” and the system
will being stand-by to wait signal from PER-Master.
Picture.5 slaver is started
2、 Press any button (key1~4) on the master board to start PER-Master
function. After the function startup is successful, LCM will display “ON” and the
system will send data by sub-1GHz RF module. LCM will update and display
parameter values (TX,LS,RX,ER,PER). LED will blink to indicate TX or RX
successful.
Picture.6 master is started
/