Havis-Shields P-MFK-9, P-REAR-1 W User manual

  • Hello! I am an AI chatbot trained to assist you with the Havis-Shields P-MFK-9 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
P-REAR-1^MFK-9_INST_9-07
INSTALLATION INSTRUCTIONS
P-REAR-1 W/P-MFK-9
REAR PARTITION W/FILLER PANEL MOUNTING KIT
1997-2008 CHEVROLET PASSENGER VANS
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
TOOLS REQUIRED:
Power drill
Drill bit set
Standard socket set
Ratcheting wrench
COMPONENTS:
QTY DESCRIPTION PART #
1 Partition P-REAR-1
1 Mounting Filler Kit P-MFK-9
P-MFK-9 COMPONENTS:
QTY DESCRIPTION
1 Passenger Side Filler Panel
1 Driver Side Filler Panel
HARDWARE:
QTY
DESCRIPTION PART #
5 ¼” x 1 ½” Hex Head Lag bolts GSM33062
2 ¼” x 3” Hex Head Lag bolts GSM33094
INSTALLATION:
Place and position partition with spring clips facing towards rear of vehicle.
Bottom frame of partition will be approximately 8 ½” from edge of door Frame.
Partition will contour trim just inside rear doors of vehicle.
Drill 3/16” pilot holes into floor of vehicle.
Loosely bolt partition to vehicle using ¼” x 1 ½” Hex head lag bolts.
Pre-drill top mounting holes with 3/16” bit. Attach to vehicle using ¼” x 3” Hex head
lag bolts.
Tighten all loose hardware
Install seat back to its original position
.
P-REAR-1^MFK-9_INST_9-07
Bottom of Rear Partition Frame & Rear Door Frame.
A
pp
rox. 8 ½”
¼” x 1 ½” Hex Head Lag Bolts
¼” x 3” Hex Head Lag Bolts
/