Step 1
For recessed installation, slide
in metal cabinet housing into
rough-in opening in wall.
For surface mounted
installation, mount metal
cabinet housing to drywall
or finished wall. Secure with
screws and wall-plugs.
Step 2
Remove Power Cover to
access ballast for wiring.
(Feed in hardwires\ through
knock-out. [
Figure 1.2
])
Step 3
Connect hardwire to ballast
to power cabinet lights. Place
back cover when wiring is
completed.
Step 4
Mount glass shelves to shelf
supports.Tighten bottom screw
to secure glass. [
Figure 1.3
]
01
BACKLIT MIRROR
CABINET INSTALLATION
Figure 1.3
Cabinet and cabinet door must be properly connected and
installed to prevent unnecessary damages or accidents
Figure 1.1
Figure 1.2
Mounting
Holes/Slots
Removable
Cover
Power
Entry
Note:
To ensure that fixture is safely secured
to the wall, fasten at least one side of
the metal housing to a wall stud for
extra support.
Power
Entry
Power
Supply
Soft-close Switch
Step 6
Carefully clip hinges to clips
inside cabinet. Then push the
hinge towards the clip until it
snaps together. [
Figure 1.5
]
Step 7
Adjust hinges’ soft-close
setting if necessary. Push
switch left to turn soft-close
mechanism on. Push right to
turn soft-close mechanism off.
[
Figure 1.6
]
ON OFF
Figure 1.6
Step 8
Once cabinet door is installed,
connect barrel connector
from cabinet to cabinet door.
[
Figure 1.7
] Close cabinet
door and turn on wall switch.
Lights should turn on without
flickering.
Figure 1.4
Step 5
Take each hinge, place into
pre-drilled holes in cabinet
door. Secure hinges with
screws. [
Figure 1.4
]
Clip pre-installed
on cabinet.
Hinge to be installed onto
cabinet door
Figure 1.7
Figure 1.5
/