2. Atdec
  3. AWM-FH

Atdec AWM-FH Installation guide

  • Hello! I've reviewed the installation guide for the Atdec AWM-FH Heavy Duty F Clamp. This document provides detailed instructions for installation, including component checklists and compatibility information. I'm ready to answer any questions you have about setting up your clamp. I can also guide you regarding features and capabilities you can find in the document.
  • What tools are required for installation?
    Is this product compatible with all work surfaces?
    What is the compatible work surface thickness?
AWM-FH Page 1 of 2
Installation Guide
AWM-FH
Heavy Duty F Clamp
COMPONENT CHECKLIST
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! This product is compatible with Atdec AWM Series products.
! The manufacturer accepts no responsibility for incorrect installation.
! Product must only be installed on a work surface capable of supporting the weight of all equipment being mounted.
! Product is not suitable for installation on work surfaces with a bullnose or bevelled edge.
D
5mm
Allen key
(x1)
B
Lower Clamp
(x1)
A
Upper Clamp
(x1)
C
Screw
M8 x 16mm
(x2)
REQUIRED TOOLS
• All tools provided
AWM-FH Page 2 of 2
1. Attach post or base to upper clamp
1.1 Option A - Attach post to upper clamp 1.2 Option B - Attach base to upper clamp
atdec.com | atdec.co.uk | atdec.com.au
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20230929
2. Attach lower clamp to upper clamp
3. Fit fixing to work surface
Fasteners
supplied
with post
Note: post sold separately Note: base sold separately
Fasteners
supplied
with base
3.1 Place in desired location on worksurface 3.2 Screw in both pressure plates
and tighten evenly and firmly
2.2 Attach lower clamp to upper clamp in the
suitable position using the two provided screws.
2.1 Measure the worksurface thickness and
choose the suitable lower clamp position
Note: If there is only a small gap behind the
worksurface, perform Step 3.1 before this step.
Post Installation Base Installation
Mounting
surface
5mm
allen key
T M B
Top
Middle
Bottom
0 - 38mm (0.00 - 1 ½”)
11 - 53mm (” - 2 ”)
25 - 68mm (1” - 2 ”)
/