AWM-FF Page 1 of 2
Installation Guide
AWM-FF
F Clamp
COMPONENT CHECKLIST
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! This product is compatible with Atdec AWM Series products.
! The manufacturer accepts no responsibility for incorrect installation.
D
5mm
allen key
(x1)
A
Upper Clamp
(x1)
B
Lower Clamp
(x1)
C
Screw
M8 x 16mm
(x2)
REQUIRED TOOLS
• All tools provided
AWM-FF Page 2 of 2
1. Attach post or base to upper clamp
atdec.com | atdec.co.uk | atdec.com.au
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20180530C
Fasteners
supplied
with post
Fasteners
supplied
with base
1.1 Option A - Attach post to upper clamp 1.2 Option B - Attach base to upper clamp
Note: post sold separately Note: base sold separately
2. Attach lower clamp to upper clamp
2.1 Measure the worksurface thickness and
choose the suitable lower clamp position
2.3 Attach lower clamp to upper
clamp in the suitable position
using the two provided screws.
(Normal position shown here)
2.2 If using inverted
position change the
screw direction of
the lower clamp
A B
A B
A B
A - Normal
0 - 36mm
(0.00 - 1 ”)
B - Inverted
36 - 79mm
(1 ” - 3”)
Note: If there is only a small gap
behind the worksurface, perform
Step 3.1 before this step.
3. Fit fixing to work surface
3.1 Place in desired location on worksurface
Post Installation Base Installation
3.2 Screw in pressure plate and tighten firmly.
5mm
allen key
Mounting
surface
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Atdec AWM-FH Installation guide
-
-
-
-
-
-
-
Atdec AWM-AD Installation guide
-
-