Instruction Manual
9” Dual Screen Portable DVD Player - BPDVD99
General Safety 4
Remote Control 7
Product Overview
Main Unit 8
Secondary Unit 10
Getting Started
Connected the Displays 12
Setup
Loading a DVD or CD 13
USB Port 13
SD Card 13
AV Output/Input 14
Troubleshooting 12
Specifications 12
Support Last Page
CONTENTS
4
GENERAL SAFETY
Read this manual thoroughly before you start using the Portable DVD Player.
Store this manual, the completed warranty card, your receipt and the product packaging.
The safety precautions instructions reduces the risk of fire, electric shock and injury when
correctly complied to.
Please follow all instructions and take notice of all warnings.
The exclamation point within the triangle is intended to
warn you to the presence of important operating and
maintenance instructions in the documents included with
the product.
5
GENERAL SAFETY (CONT.)
This product must be positioned in a suciently stable location, it can be potentially
hazardous due to falling from furniture and can cause injury, particularly to children.
• The apparatus shall not be exposed to dripping or splashing and no objects filled with
liquids, such as vases, shall be placed on the product. Dry location use only.
• No naked flame source, such as candles, should be placed on the product.
• Unplug ths product during lightning storms or when unused for long periods of time.
Not doing so may result in fire or electric shock.
• Do not cover the ventilation openings of the product with items such as newspapers,
tablecloths, curtains etc or insert objects into the slots available on the products.
As this could result in the product temperature rising and could cause a fire.
• Do not expose this appliance to rain or moisture as it may result in fire or an
electric shock hazard
• Do not tamper or change or modify the product in any way.
• Only use Accessories outlined and recommended by the manufacturer.
• Please do not expose the product to splashing or water contact
• Please do not place any object on top of the product including objects filled with liquids
such as vases.
• Danger of explosion if battery is incorrectly placed. Replace with same or equivalent type.
IMPORTANT INFORMATION
6
GENERAL SAFETY (CONT.)
Please make sure upon positioning this product, the place is:
• Not wet or damp and Well ventilated
• Away from direct sunlight or heaters.
• Away from splashes or food.
• Protected from excessive dust or grease.
• Do not install this equipment in a confined space such as a bookcase or similar unit.
• Do not install the DVD Player set near heat sources such as radiators, stoves or other audio
visual equipment that produce heat.
• Do not place containers with liquids, if liquid falls inside the products it may result in
short-circuit, fire or electric shock.
• Do not place small metallic objects on top of the unit. Metal object falls inside the
product it may result in short-circuit, fire or electric shock.
• Do not use or store flammable or combustible materials near the unit. Doing so may
result in fire or explosion. Do not place any naked flame sources, such as lit candles,
cigarettes or incense sticks.
• Do not expose the DVD player and remote control to direct sunlight and excessive
heat inside vehicles.
• Only use the power adaptor provided with this unit.
LASER SAFETY
This set employs an optical laser beam system in the disc mechanism
designed with built-in safeguards. Do not attempt to disassemble. Exposure
to this invisible laser light beam may be harmful to the human eye.
This is a Class-1 laser product. Use of controls, adjustments or procedures
other than those specified herein may result in hazardous laser light
beam exposure.
This DVD player should not be adjusted or repaired by anyone except
qualified service personnel. The laser mechanism in the set corresponds to
the stylus (needle) of a record player. Although this product uses a laser
pick-up lens, it is completely safe when operated according to directions.
7
REMOTE CONTROL
Batteries
Requires 2 x AAA batteries (included)
8
PRODUCT OVERVIEW
MAIN UNIT
9
MAIN UNIT
PRODUCT OVERVIEW (Cont.)
10
PRODUCT OVERVIEW (Cont.)
SECONDARY UNIT
11
PRODUCT OVERVIEW (Cont.)
SECONDARY UNIT
12
GETTING STARTED
Connecting the Displays
Requires a 3.5mm A/V/DC Cable (included), AC/DC power adapter (included),
or 12V DC car adapter (included).
Note: Secondary display cannot function by itself and must be connected to the Main display.
1. Plug the included AC/DC power adapter into a wall outlet, or plug the 12V DC
car adapter into the cigarette lighter of your vehicle, then plug the other end to
the DC IN on the MAIN DISPLAY.
2. Plug the AV/DC cable into the AV Output and DC Output on the MAIN DISPLAY and
the AV Input and DC Input on the SECONDARY DISPLAY.
3. Audio and video played on the Main display can now be seen on the
secondary display.
It is recommended to charge the unit fully before initial use. The Battery Indicator on the
Main unit will display a red light when the unit is charging, and a green light when the unit
is fully charged.
13
SETUP
LOADING A DVD OR CD
Loading a Disc
1. Press the Open button to open the Disc Door.
2. Load a disc into the DVD player, label side facing up.
3. Manually close the Disc Door.
After a disc is loaded, it will begin playing automatically.
Playing a Loaded Disc
1. Follow the instructions for Loading a Disc.
2. If the disc does not begin playing automatically, press the Play/Pause button.
Programming a Loaded Disc
1. Follow the instructions for Loading a Disc and Playing a Loaded Disc.
2. While the loaded disc is playing, press the Program button on the remote.
3. Use the Number Keypad to enter in the titles and chapters in the order you want to
view them.
DVD Titles and chapters or CD tracks will play in the order they are programmed.
4. Repeat step 3 until the desired DVD titles and chapters or CD trcks are programmed.
USB PORT
Connecting a USB Thumb Drive
Connect a USB Thumb Drive to the USB Port. Picture formats are supported (Jpeg).
Accessing the Content on a USB Drive
1. Follow the instructions for Connecting a USB thumb drive.
2. Press the DVD/SD/USB button to enter DVD/SD/USB mode.
SD CARD
Connecting a SD CARD
Note: Formats are not universally compatible. Playback may be dependent on
recording conditions.
1. Follow the instructions for Connecting a Memory Card.
2. Press and hold the DVD/SD/USB Button to enter DVD/SD/USB mode.
14
SETUP (Cont.)
AV OUTPUT AND INPUT
Using the 3.5mm AV Output
Connect the 3.5mm to 3 x RCA audio/Video cable to the 3.5 mm AV output on the portable
DVD player and the composite video and sudio input on a television.
Audio and video played through the portable DVD player will now be output through the
connected television.
15
SPECIFICATIONS
TROUBLESHOOTING
Power Supply Adaptr: DC 12V 2A
Car Charger: DC 12V 2A
Power Consumption 18W
Battery Type 7.4V 1800mAh Lithium Polymer Rechargeable battery
Compatiable Disc Formats DVD,CD,CD-RW, JPEG
Signal System PAL/NTSC/AUTO
Frequency Response 20Hz to 20KHz
Operating Temperature 5-40˚c
Car Adaptor Fuse 3A
CUSTOMER HELPLINE:
info@ayonz.com
DISTRIBUTED BY:
Ayonz Pty Ltd
/