2. Traulsen
  3. G_RA-Series Ref_Frz_Hot Food Reach-In EZ-Open Foot Pedal

Traulsen G_RA-Series Ref_Frz_Hot Food Reach-In EZ-Open Foot Pedal Installation guide

  • Hello! I have reviewed the Traulsen EZ-Change Interiors installation instructions. This document provides guidance on installing pilasters and trayslides for reach-in cabinets. It details procedures for mounting components in different cabinet configurations, upper or lower mounting, and utilizing the TRAULSEN EZ alignment system. I'm here to help with any questions you might have about the installation process or the components themselves.
  • How do I install pilasters if the holes are in the front and back walls of the cabinet?
    How do I install pilasters if the holes are on the sides of the cabinet?
    How do I install the trayslides?
Traulsen 4401 Blue Mound Road Fort Worth, TX 76106 | 800-825-8220
Description Part Number
A #1 Pilaster 342-60134-00
B Universal Pilaster 342-60133-00
C Mounting Bracket 342-60135-00
D #1 Trayslides 701-61614-00
E Universal Trayslides 701-61613-00
F Heavy Duty Universal Trayslides 701-61613-01
G Shoulder Screw 351-60127-00
H umb Screw 351-15822-01
EZ-Change Interiors
For All Reach-In Cabinets
TRAULSEN
INNOVATIONS
Pilaster installation for holes in front and back wall of cabinet
1) Remove all pre-existing shelves and shelf pins.
2) Align mounting bracket C with desired upper or lower mounting holes in
back wall of cabinet. Attach mounting bracket C with thumb screws H.
3) For mounting in upper half of cabinet: In mounting bracket C, attach
shoulder screws G in hole numbers 3, 5 and 9 (counting down the holes from
the top of the cabinet).
4) For mounting in lower half of cabinet: In mounting bracket C, attach
shoulder screws G in hole numbers 1, 5 and 7 (counting up from the bottom
of the cabinet).
5) Drop and secure appropriate pilaster A or B on to mounting bracket C.
6) Repeat steps 2 – 4 for other bracket and pilaster in the pair.
7) Drop tray slides D, E or F into pilaster slots using the TRAULSEN EZ letters
to align.
NOTE: Pilasters can be used in either upper or lower mounted applications.
traulsen.com/service-parts
Upper Mounting
(C)
(H)
(G)
(A) or (B)
Lower Mounting
Pilaster installation for holes on sides of cabinet
1) Remove all pre-existing shelves and shelf pins.
2) For mounting in upper half of cabinet: Attach shoulder
screws G in hole numbers 2, 3 and 5 (counting down the
holes from the top of the cabinet).
3) For mounting in lower half of cabinet: Attach shoulder
screws G in hole numbers 1, 3 and 4 (counting up from the
bottom of the cabinet).
4) Drop and secure appropriate pilaster A or B on to shoulder
screws G.
5) Drop tray slides D, E or F into pilaster slots using the
TRAULSEN EZ letters to align.
NOTE: Pilasters can be used in either upper or lower mounted
applications.
(D), (E) or (F)
(trayslides for both installations)
Upper Mounting
Lower Mounting
(B)
(C)
(G)
(G)
Accessory Installation Instructions
R- and A-Series Pre-Installed Pilasters
1) Remove shipping screw from top hole in all pilasters.
2) Drop tray slides D, E, or F into pilaster slots using the TRAULSEN EZ letters to align.
/