Traulsen G-Series 2-Sec Heated Cabinet Trayslide Installation guide

TRAYSLIDE GUIDE: How to Install on G-Series Heated Cabinets

1. First remove the shelves and clips from the pilasters that are shipped with the unit. the universal trayslides will be installed on the

original pilasters.

2. (Fig. 2a-2b) Begin installing the trayslides on one side from bottom to top.

• Insert the bottom set of tabs into the slots at desired height.

• On one side, insert the top tab into the pilaster slot, and tap the top of the trayslide near that pilaster with a rubber mallet.

• Repeat on the other side of the trayslide while being careful not to unseat the side that was installed rst.

• Once both ends are seated in the pilaster slots, tap the top of the trayslide with a rubber mallet near both pilasters to secure it.

3. Repeat step 1 on the other side of the cabinet.

• Be sure to check that the trayslides match up with the ones installed on the other side.

4. Test on the top set, middle set, and bottom set of trayslides to make sure that the trayslides have been installed level

*NOTE: 2 sets of trayslides are needed to equip both sections on 2-section models.*

Bottom Support 18x26 or 12 x20 Pans

2a 2b

INSTALL UNIVERSAL TRAYSLIDES

TRAYSLIDES: G-SERIES 2-SECTION

HEATED CABINET

KIT MODEL: G23ACC-TK4LR

TRAYSLIDE PART: 701-60039-00

QTY: 7 PAIRS OF UNIVERSAL TRAYSLIDES

RECOMMENDED TOOLS: Rubber Mallet

(08-23) TR36122