![](//vs1.manuzoid.com/store/data-gzf/175b58f3419d5cf8d908c3c567748387/2/001270125.htmlex.zip/bg4.jpg)
©2006 –2017 SnapAV. 1800 Continental Blvd Suite 200, Charlotte, NC 28273 170905
10. Bind Sources/Zones signals with interface for control/feedback of those features.
11. Compile and transfer to controller.
12. Create and compile/transfer interface.
13. Basic control of the ampilier should now be enabled.
NOTE: Add the autonomic controls mirage amp source selection handler module to the logic folder.
This will simplify the autonomic controls mirage amp controller module Zone Current Source
signal. The Current_Source signal binds to Current_Source.
NOTE: It is recommended that all ampliers in a system run the same rmware.