Autonomic AU-M-801E User guide

Brand
Autonomic
Model
AU-M-801E
Type
User guide

This manual is also suitable for

Questions? 866.838.5052 or techsupport@snapav.com
©2006 –2017 SnapAV, 1800 Continental Blvd # 300, Charlotte, NC 28273
Driver
Install Guide
Use the following procedure to create a program allowing control of Autonomic ampliers via a
Crestron control system.
NOTE: Remote sources are only supported on sSeries ampliers.
Requirement: A computer with a SIMPL Windows and a Crestron series 2 or 3 processor installed.
1. Create SIMPL windows project with your crestron controller/interface.
2. Expand/Add TCP/IP_Client: TCP/IP Client module to the Ethernet slot on the controller.
3. Add autonomic controls mirage amp controller module to logic folder.
Questions? 866.838.5052 or [email protected]om
©2006 –2017 SnapAV. 1800 Continental Blvd Suite 200, Charlotte, NC 28273 170905
4. Expand ethernet slot and double click TCP/IP Client to congure ip address of mirage amp.
5. Double click autonomic mirage amp controller module and bind TX and RX to TCP/IP_Client TX
and RX.
6. Set port parameter on TCP/IP_Client to 17037.
7. Bind debug_enabled signal with 0/1, 0 being disable debug.
Questions? 866.838.5052 or [email protected]om
©2006 –2017 SnapAV. 1800 Continental Blvd Suite 200, Charlotte, NC 28273 170905
8. Pulse the initialize signal once the TCP/IP connection is ready.
9. Bind All_On/All_Off/Refresh_Source_Metadata signals with interface for control of those
features.
Questions? 866.838.5052 or [email protected]om
©2006 –2017 SnapAV. 1800 Continental Blvd Suite 200, Charlotte, NC 28273 170905
10. Bind Sources/Zones signals with interface for control/feedback of those features.
11. Compile and transfer to controller.
12. Create and compile/transfer interface.
13. Basic control of the ampilier should now be enabled.
NOTE: Add the autonomic controls mirage amp source selection handler module to the logic folder.
This will simplify the autonomic controls mirage amp controller module Zone Current Source
signal. The Current_Source signal binds to Current_Source.
NOTE: It is recommended that all ampliers in a system run the same rmware.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Autonomic AU-M-801E User guide

Brand
Autonomic
Model
AU-M-801E
Type
User guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents