2. Autonomic
  3. AU-M-120E

Autonomic AU-M-120E, AU-M-401E, AU-M-801E User guide

  • Hello! I am an AI chatbot trained to assist you with the Autonomic AU-M-120E User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Questions? 866.838.5052 or techsupport@snapav.com
©2006 –2017 SnapAV, 1800 Continental Blvd # 300, Charlotte, NC 28273
Driver
Install Guide
Use the following procedure to create a program allowing control of Autonomic ampliers via a
Crestron control system.
NOTE: Remote sources are only supported on sSeries ampliers.
Requirement: A computer with a SIMPL Windows and a Crestron series 2 or 3 processor installed.
1. Create SIMPL windows project with your crestron controller/interface.
2. Expand/Add TCP/IP_Client: TCP/IP Client module to the Ethernet slot on the controller.
3. Add autonomic controls mirage amp controller module to logic folder.
Questions? 866.838.5052 or [email protected]om
©2006 –2017 SnapAV. 1800 Continental Blvd Suite 200, Charlotte, NC 28273 170905
4. Expand ethernet slot and double click TCP/IP Client to congure ip address of mirage amp.
5. Double click autonomic mirage amp controller module and bind TX and RX to TCP/IP_Client TX
and RX.
6. Set port parameter on TCP/IP_Client to 17037.
7. Bind debug_enabled signal with 0/1, 0 being disable debug.
Questions? 866.838.5052 or [email protected]om
©2006 –2017 SnapAV. 1800 Continental Blvd Suite 200, Charlotte, NC 28273 170905
8. Pulse the initialize signal once the TCP/IP connection is ready.
9. Bind All_On/All_Off/Refresh_Source_Metadata signals with interface for control of those
features.
Questions? 866.838.5052 or [email protected]om
©2006 –2017 SnapAV. 1800 Continental Blvd Suite 200, Charlotte, NC 28273 170905
10. Bind Sources/Zones signals with interface for control/feedback of those features.
11. Compile and transfer to controller.
12. Create and compile/transfer interface.
13. Basic control of the ampilier should now be enabled.
NOTE: Add the autonomic controls mirage amp source selection handler module to the logic folder.
This will simplify the autonomic controls mirage amp controller module Zone Current Source
signal. The Current_Source signal binds to Current_Source.
NOTE: It is recommended that all ampliers in a system run the same rmware.
/