ESAB Remote Hand Switch Installation guide

Remote Hand Switch:

25 ft. (7.6m) lead ....................................p/n 0558008349

50 ft. (15.2m) lead ..................................p/n 0558009277

Enables non-automated mechanized cutting using

the PT-37 torch. Can be used on PC-900/1300/1600

(Manual or Mechanized versions) machines

equipped with or without CNC interface connec-

tion pigtail. Connects to the torch cable receptacle

through the front panel access door strain relief.

Remote Hand

Switch cable

connectors

Strain Relief

Torch Lead

Access Door

Mechanized

Torch Connectors

1. Remove Torch Lead Access Door from

front of power source.

2. Remove and disassemble strain relief by

unscrewing two phillips head screws that

attach the two halves of the strain relief.

3. Disconnect mechanized torch connectors.

4. Place Remote Hand Switch cable on torch

cable and replace strain relief with Remote

Hand Switch cable inserted in notch of

strain relief. Reassemble and tighten strain

relief halves.

5. Connect Remote Hand Switch cable con-

nectors to torch cable connectors from

plug.

6. Position strain relief in front panel notch.

7. Replace Torch Lead Access Door.

Remote Hand SwitcH

PC-900/1300/1600 Installation Instructions

To install the Remote Hand Switch:

0558010102 08/2011