2. Oneida Air Systems
  3. AXD000009

Oneida Air Systems AXD000009 Operating instructions

  • Hello! I've reviewed the user manual for the Ultimate Dust Deputy and its attachment to Festool 2018 models. This document provides instructions on how to properly connect the dust collector using the Festool's latches and tubing for effective dust management. I'm ready to answer any questions you might have about the installation process.
  • How many latches need to be unlatched on the Festool?
    Which latches should be closed first over the Dust Deputy tabs?
    What size tubing is used for the connection?
Attaching the Ultimate Dust Deputy
to the Festool 2018 Models
The latest versions of the Festool dust extractors have new xturing for accessory attachment. Please follow
these instructions to attach your Ultimate Dust Deputy to the newest version of the Festool.
1. Unlatch the 4 green latches on top of the Festool.
2. Place the Ultimate Dust Deputy on top of the Festool
vacuum and line up tabs on box with Festool
latches A & B. The latches and tabs will only align
one way.
3. Close latches A&B rst over the Ultimate Dust Deputy
box tabs. Figs. 3 & 4 & 5 below.
4. Secure the two latches that open on the other side
of the Festool over the Ultimate Dust Deputy tabs.
Figs. 6 & 7 below.
The latches t into notches
on the Ultimate Dust
Deputy box.
Fig. 1 - Festool, all latches open Fig. 3 - Festool latches
A & B open
Fig. 5 - Festool latch
locked in place.
Fig. 6 - Festool latches
C & D opened.
Fig. 7 - Festool latches
C & D closed.
Fig. 4 - Dust Deputy tabs
lined up with Festool
latches A & B
Fig. 2 - Ultimate Dust Deputy tabs
Latch A
Latch C
Tab
Tab
Latch D
Tab
Tab
Latch B
5. Run the 1/4” tubing across the Ultimate Dust Deputy
to th SD elbow with tting (AXD600104) on the Festool.
Figs. 8 & 9 below.
6. Attach the SD elbow without the tting (AXD600103)
to the outlet of the Dust Deputy. Figs. 10 & 11 below.
7. Run the 2” hose between the SD elbow without the
tting on the top of the Dust Deputy cyclone and the
elbow with the tting on the Festool as shown in Fig.
12 below.
Fig. 8 - 1/4” tubing connected
Fig. 9 - Elbow with tting
(AXD600104)
Fig. 12 - 2” hose between
the Ultimate Dust
Deputy and the Festool.
Fig. 11 - Elbow without
tting
(AXD600103)
Fig. 10 - SD Elbow without tting
attached to cyclone outlet.
/