Simply Conserve QEBD650 84 B-125 Installation guide

1701 Charleston Regional Parkway Suite A | Charleston, SC 29492

Phone: 843.971.1414 | Fax: 843.971.1472 | Customer Toll-Free: 800.GOOD.BUY or 800.777.5665

www.amconservationgroup.com

Replacement Foam Door Seal Weather Strip Installation Instructions and

Warranty

You will need: Measuring tape and scissors

Step 1:

Remove old weatherstrip gasket by sliding out of carrier, if necessary. Clean

carrier/door jamb stop.

Step 2:

Measure the length of the carrier or door stop at the top of the door. Cut a

piece of the weatherstrip to fit. Insert cut piece into top of door carrier with

open sides of the “v” facing upwards.

Step 3:

Measure the left and right door jamb stop and cut to size. Starting at the

top of the door insert the piece into each side door jamb stop pressing

firmly into place. The “v” should be facing toward the door jamb. Trim

excess length with scissors if needed.

Product Warranty:

This product is warranted to be free from defects in material and workmanship for one year. For

replacement product, contact custo[email protected]om and have proof of

purchase available. Manufacture may require original product to be shipped back for evaluation

and/or pictures of defective product to be provided.