Simply Conserve KC600G-96-25 Installation guide

1701 Charleston Regional Parkway Suite A | Charleston, SC 29492

Phone: 843.971.1414 | Fax: 843.971.1472 | Customer Toll-Free: 800.GOOD.BUY or 800.777.5665

www.amconservationgroup.com

KC600 Door Seal Weather Strip Installation Instructions and Warranty

You will need: Measuring tape, a hacksaw, and a drill

Step 1:

Carefully measure the top width of the doorstop.

Step 2:

Cut, if necessary, the 36 in. top section and install with the door closed

using the included screws. The foam gasket side should make light contact

with the door. The slotted screw holes allow for adjustment. Tighten screws

for a secure fit.

Step 3:

Repeat this process for the left and right sides, measuring from the top of

the doorstop to the threshold of the floor.

Note – Each side piece is angled to fit the top 36 in. section. Do not cut the

angled top of the side pieces; cut the non-angled end for best fit.

Product Warranty:

This product is warranted to be free from defects in material and workmanship for seven years.

For replacement product, contact customercare@amconservationgroup.com and have proof of

purchase available. Manufacture may require original product to be shipped back for evaluation

and/or pictures of defective product to be provided.