Minka Lavery 9909-1-66 User manual

Type
User manual
READ AND SAVE THESE INSTRUCTIONS
F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURAN
NIVEAU DES FUSIBLES OU DU DISJONCTE
INSTALLATION INSTRUCTIONS
For Model 9909-94/9909-61/9909-91/9909-161
READ AND SAVE THESE INSTRUCTIONS
W
A R N I N G ! S H
U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove old fixture,
including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a
clear area. Take care not to lose any small parts necessary for
installation.
3. Thread the 2 mounting screws (E) to the mounting strap (B)
(You can adjust the length of the screws if necessary).
4. Attach the mounting strap (B) to the outlet box (A) (not supplied)
by using the 2 screws (C) provided with the outlet box (A).
5. CONNECTING THE WIRES (Fig. 2)
At the point, connect the electrical wires as follows:
Connect the black wire from the fixture to the black (hot) house
wire. Connect the white wire from the fixture to the white
(neutral) house wire. Make sure all wire nuts are secured. You
may wrap the connections with electrical tape. If your outlet has a
ground wire (green or bare copper), connect fixtures ground wire
to it. Otherwise, connect fixtures ground wire directly to the
mounting strap by using the green screw provided. Tuck the
wire connections neatly into the junction box.
6. Attach the canopy (G) to the mounting strap (B) by insert the
two screws (E), and then secure with the 2 cap nuts (F).
7. Install bulbs. (Type-B. not supplied). Attach the glass shade (H)
up to the canopy (G).
8. Finally attach the bottom cover (J) and secure with the hex nut
(K) and the finial (M).
9. Turn on the power at fuse or circuit box.
DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Fig. 1
Fig. 2
FIXTURE FIXTURE
WIRES WIRES
Black or White or
Smooth Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE HOUSE
WIRES WIRES
White Green or
(Neutral) Bare
Copper
(Ground)
Your installation is now complete. Return power to the
junction box and test the fixture.
  • Page 1 1

Minka Lavery 9909-1-66 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI