2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Pioneer
  7. Car Fascia kit for Toyoto

Pioneer Car Fascia kit for Toyoto Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Pioneer Car Fascia kit for Toyoto Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTALLATION INSTRUCTIONS FOR PART 95-8204
95-8204
KIT FEATURES
• Double DIN Radio Provision
• Stacked ISO Units Provision
A) Double DIN Trim Plate B) Double DIN Brackets
KIT COMPONENTS
A
Small Flat Blade Screwdriver • Panel Removal Tool
• Phillips Screwdriver • Socket Set
1-800-221-0932
© COPYRIGHT 2004 METRA ELECTRONICS CORPORATION
www.metraonline.com
TOOLS REQUIRED:
APPLICATIONS
Toyota Corolla
2003-2007
B
2-DIN 12.301300-02
Dash Disassembly
- Totota Corolla 2003-2007 ..........................................1
Kit Assembly
- Double DIN Radio Provision .......................................2
- Stacked ISO Units Provision.......................................3
Final Assembly ..........................................4
TABLE OF CONTENTS
95-8204
*Note:
Refer also to the instructions included with the aftermarket radio.
95-8204 DASH DISASSEMBLY
TOYOTA COROLLA 2003-2007
A
B
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unclip and remove the gear shifter
trim panel.
(Figure A)
2
Remove the center a/c knob and (1)
Phillips screw exposed behind it.
(Figure B)
3
Unclip and remove the a/c-pocket
assembly.
(Figure C)
4
Remove (4) 10 MM bolts from the bot-
tom of the radio then unclip and
remove the factory radio and trim
panel together. Unplug radio from fac-
tory harness.
(Figure D)
5
Unclip and remove the radio trim
panel including the a/c vents from the
factory radio.
6
Continue to kit assembly.
PASSENGER
A/C
LO
OFF
HI
C
PASSENGER
A/C
L
O
OF
F
HI
D
A/C
P
R
N
D
2
L
2
95-8204 KIT ASSEMBLY
B
A
DOUBLE DIN RADIO PROVISION
Slide the Double DIN radio into the
Double DIN brackets and secure the
radio to the brackets using the screws
supplied with the radio.
(Figure B)
2
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
Snap the Double DIN trim plate into the
factory trim panel.
(Figure A)
1
3
95-8204 KIT ASSEMBLY
B
A
STACKED ISO UNITS PROVISION
Slide the stacked ISO units into the
Double DIN brackets and secure the
units to the brackets using the screws
supplied with the units.
(Figure B)
2
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
Snap the Double DIN trim plate into the
factory trim panel.
(Figure A)
1
/