Brodit 855034 Datasheet

Product 855034

855034 ProClip

Angled mount. Notice: This mount will only fit models with a seam on the back side of the console-mounted

passenger assist handle. Please check the handle for a seam.

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for

your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is

car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required

and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

EAN: 7320288550343

Item no 855034 fits:

Chevrolet Corvette 14-15 (For all countries)

1(2)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please read the instructions and look at the pictures before installing the ProClip.

1. Insert the left angled edge of the ProClip into the seam between the two padded panels on the back side of the

center console pillar. Adjust placement or location of ProClip on the pillar if desired.

2. Press the thin end of the enclosed gap opener between the padded part of the center console pillar and the

plastic trim piece on the driver's side of the pillar, to widen the gap.

3. Place your fingers behind the face plate of the ProClip and flex/hook the angled right edge of the ProClip into

the gap next to the gap opener. Remove the gap opener.

4. The ProClip is in place.

2(2)

Download PDF