29 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 855034
855034 ProClip
Angled mount. Notice: This mount will only fit models with a seam on the back side of the console-mounted
passenger assist handle. Please check the handle for a seam.
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288550343
Item no 855034 fits:
Chevrolet Corvette 14-15 (For all countries)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read the instructions and look at the pictures before installing the ProClip.
1. Insert the left angled edge of the ProClip into the seam between the two padded panels on the back side of the
center console pillar. Adjust placement or location of ProClip on the pillar if desired.
2. Press the thin end of the enclosed gap opener between the padded part of the center console pillar and the
plastic trim piece on the driver's side of the pillar, to widen the gap.
3. Place your fingers behind the face plate of the ProClip and flex/hook the angled right edge of the ProClip into
the gap next to the gap opener. Remove the gap opener.
4. The ProClip is in place.
2(2)
/