ACCESSORY INSTALLATION
INSTRUCTIONS
RAIL MOUNTED ROD HOLDER
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/17/2010
REV. B
PROCEDURE NO.
AI-MS-017
Pa
g
e 2 of 2
1. PURPOSE
Provide step-by-step procedure for the rail mounted
rod holder installation.
2. SCOPE
This procedure is limited to the rail mounted rod holder
installation on the 130, 150 & 170 Super Sport.
3. DEFINITION
3.1. Not Applicable
4. RESPONSIBILITY
4.1. Not Applicable
5. TOOLS/EQUIPMENT REQUIRED
5.1. Hex Wrench (supplied)
5.2. Hardware (supplied)
6. SAFETY
6.1. Safety glasses or goggles are recommended.
7. FORMS
7.1. Not applicable
CONTENTS OF KIT PART #
1- ROD HOLDER. . . . . . . . . . . . .1952622
2- CLAMSHELL BRACKET (SUPPLIED)
3- HARDWARE (SUPPLIED)
Page 1 of 3
ACCESSORY INSTALLATION
INSTRUCTIONS
RAIL MOUNTED ROD HOLDER
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/17/2010
REV. B
PROCEDURE NO.
AI-MS-017
8. PROCEDURE
8.1. Place the rod holder on the rail at the desired location
(as shown).
8.2. Using the Hex Head wrench and the hardware supplied, insert
and tighten the bolts at the six (three top & three bottom)
locations on the clamshell clamp.
Rail Mounted rod holder Installation Is Complete
To adjust the rod holder
8.3. Completely remove the knob on the rod holder by turning
counterclockwise.
Page 2 of 3
ACCESSORY INSTALLATION
INSTRUCTIONS
RAIL MOUNTED ROD HOLDER
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/17/2010
REV. B
PROCEDURE NO.
AI-MS-017
8.4. Remove the rod holder from the rail mount.
8.5. Rotate the rod holder to the desired position.
8.6 Replace the rod holder onto the rail mount.
/