2. Vehicles & accessories
  3. Motor vehicle electronics
  4. Car subwoofers
  5. B C SPEAKERS
  6. WGX1090TN
WGX1090TN

B C SPEAKERS WGX1090TN Operating instructions

  • Hello! I've reviewed the datasheet for the B&C Speakers WGX1090TN Line Array Source. This document details the specifications for a 1.4-inch line array source, covering aspects like its 120° horizontal coverage, 240W power handling, and 100mm aluminum voice coil. I am ready to assist with any questions you might have regarding this device or its features.
  • What is the maximum horizontal coverage of the line array source?
    What is the continuous program power capacity?
    What is the diameter of the voice coil?
    What is the frequency range?
    What is the sensitivity of the device?
Line Array optimized Waveguide with DE1090TN
driver
120° max horizontal coverage
240 W continuous program power capacity
100 mm (4 in) aluminium voice coil
Titanium diaphragm
500 - 18000 Hz response
108 dB sensitivity
Neodymium magnet assembly with shorting
copper cap
Wave guide horn not sold separately
WGX1090TN
Line Array Sources - 1.4 Inches
8Ω
B&C Speakers s.p.a.
Via Poggiomoro, 1 - Loc. Vallina, 50012 Bagno a Ripoli (FI) - ITALY - Tel. +39 055 65721 - Fax +39 055 6572312 - mail@bcspeakers.com
WGX1090TN
Line Array Sources- 1.4 Inc hes
120 ° Max
93.7 %
0.8 kHz
Cast Aluminium
8 Ω
8.0 Ω
120 W
240 W
108.0 dB
0.5 - 18.0 kHz
100 mm (4.0 in)
Aluminium
Titanium
1.9 T
Neo Inside Ring
SPECIFICATIONS
Horizontal Coverage
Active Radiating Factor
Recommended Crossover1
Waveguide Material
Nominal Impedance
Minimum Impedance
Nominal Power Handling2
Continuous Power Handling3
Sensitivity4
Frequency Range5
Voice Coil Diameter
Winding Material
Diaphragm Material
Flux Density
Magnet Material
153x25 mm (6x1 in)
127 mm (5.0 in)
163x130x234 mm (6.42x5.12x9.21 in)
2.9 kg (6.39 lb)
1
3.0 kg (6.61 lb)
245x140x175 mm (9.6x5.5x6.9 in)
MOUNTING AND SHIPPING INFO
Exit Size
Driver Diameter
Dimensions
Net Weight
Shipping Units
Shipping Weight
Shipping Box
1. 12 dB/oct. Or higher slope high-pass filter.
2. 2 hour test made with continuous pink noise signal (6 dB crest factor) within the range from the recommended crossover frequency to 20 kHz. Power
calculated on rated minimum impedance.
3. Power on Continuous Program is defined as 3 dB greater then the Nominal rating.
4. Applied RMS Voltage is set to 2.83 V for 8 ohms Nominal Impedance.
5. Waveguide mounted on 90°x10° bell horn
B&C Speakers s.p.a.
Via Poggiomoro, 1 - Loc. Vallina, 50012 Bagno a Ripoli (FI) - ITALY - Tel. +39 055 65721 - Fax +39 055 6572312 - mail@bcspeakers.com
/