Product (1:1) Print scale test
NOTICE! This document is ONLY for illustrating the drill
holes of the Easee Charging Robot backplate. Make sure
to read the product manual carefully before installing and
operating the product.
Download product manuals at http://easee.support
Or scan the QR code:
Make sure to print the document 100% in scale (A4) for the
most accurate result. Use the the ruler below to check the
printer scale. The line is 3cm in width.
Included screws
Easee
Charging Robot
Backplate
July 2022 - Version 1.00
© 2022 by Easee AS. All rights reserved.
x4
5mm