2. Juno
  3. P4677

Juno P4677 User manual

  • Hello! I'm a chat assistant that has reviewed the Installation Instructions for the Juno H-Type Adapter. This document provides clear, step-by-step guidance on how to properly install the adapter onto a track, including the alignment and latching mechanisms as well as instructions to prepare for second circuit positioning using flat head screwdriver. I'm ready to answer any questions you might have about this setup.
  • Where is the latch located?
    What tool is needed for second circuit positioning?
    What should happen after inserting the adapter box into the track?
INSTALLATION INSTRUCTIONS
For H-Type Adapter
1300 S. Wolf Road • Des Plaines, IL 60018 • 800-323-5068 •www.acuitybrands.com
©2017 Acuity Brands Lighting, Inc. Rev 4/18 P4677
1 of 1
Find the latch and the polarity line.
Align parts as shown below and
insert the adapter box into the track
Rotate the adapter box opposite
the arrows until the latch snaps in
place between the two track rails Final Position
SAVE THESE INSTRUCTIONS
Polarity Line
Latch on
adapter box
Continue to depress
latch until final position Latch snaps into place
between rails
Second Circuit Positioning
1. Hold onto Adapter Box with one hand
2. Place the end of a flat head screw driver under the contact shown below
3. Gently pull up, the contact should move vertically until hitting a hard stop
4. Follow instructions for inserting into track
Place flat head under the contact
Final Position
Rotate adapter
box opposite
the arrows
Coming Soon
/