1
Outdoor
GP I :ENERAL RODUCT NFORMATION
This product is safety listed for wet locations.
This instruction shows a typical installation.
1
2
1A
3
4
5
Installation Instructions for
Galena Outdoor Post
1.0
O 14406-L OL14407
OL14406, OL14407
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Secure the fixture to the post with the post screws making sure to neatly tuck in all wiring.
Screw the fixture loop to the top of the fixture.
Install the candle tube by sliding it over the socket.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Place the housing over the housing base, and secure it in place using the housing screws.
POST
POST SCREW
6
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
2
3
4
CANDLE TUBE
HOUSING BASE
HOUSING SCREW
4
HOUSING
LAMP
SOCKET
7
FIXTURE LOOP
8
