6
1
Installation Instructions for
Jacksboro 1, 2, and 3 Light Vanity Strip
1.0
V 2320_S
VS23201,VS23202,
VS23203
Secure the mounting plate to the junction box.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Install the candle tubes by slipping them over the sockets.
Install candle follower onto the top of the candle tube.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Install the shade by placing it inside the shade base. Repeat steps 6-9 for remaining sockets.
1
2
3
1A
LAMP
4
HOT
WIRE
BLACK
WIRE
MOUNTING
PLATE
NEUTRAL
WIRE
WHITE
WIRE
5
6
Wall
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for damp locations.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SOCKET
SHADE
7
JUNCTION
BOX
1
1
5
4
3
CANDLE FOLLOWER
CANDLE TUBE
FIXTURE
SCREW
8
9
SHADE BASE
7
8
9
Page is loading ...
Page is loading ...
SAVETHESE INSTRUCTIONS!
4
7400 Linder Ave, Skokie, 60077IL
800.969.3347
www.Feiss.com
© 2016 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
/
