Legrand 882C/884C Series Single-Service Round PVC Floor Box - 882C, 884C, 882C-4LEV Installation guide

Hello! I am an AI chatbot trained to assist you with the Legrand 882C/884C Series Single-Service Round PVC Floor Box - 882C, 884C, 882C-4LEV Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

PVC Floor Box

882C, 884C, and 882C-4LEV

INSTALLATION INSTRUCTIONS

Walker

electrical systems conform to and should

be properly grounded in compliance with

requirements of the current National Electrical

Code or codes administered by local authorities.

All electrical products may present a possible

shock or fire hazard if improperly installed or

used. Walker electrical products may bear the

mark as UL Listed and/or Classified and should

be installed in conformance with current local

and/or the National Electrical Code.

IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.

Products Covered: 882C, 884C, and 882C-4LEV

Step 1. Install knockouts and reducers into box. Step 2. Secure box to concrete form.

NOTE: Bushings are supplied with box (882C or 884C) for installation NOTE: Be sure mudcap is in place to prevent concrete from

on conduit or to blank unnecessary outlets. To assure a clean entering box.

knockout of the bushing, use a ball peen hammer or a large

blunt punch before installing. Then insert bushing and solvent

cement into box.

Step 3. Mark line to box finish height after concrete Step 4. Cut off excess box at line scribed with a

has been poured. wood saw.

Mudcap

The Wiremold Company

U.S. and International:

60 Woodlawn Street • West Hartford, CT 06110

1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251

Canada:

850 Gartshore Street • Fergus, Ontario N1M 2W8

1-800-741-7957 • FAX 519-843-5980

1 001 613 1001

Step 5. Wire devices using pattern 1 and attach ring to cover using the hole pattern B as shown.

Step 6. Apply solvent cement to leveling ring Step 7. Line up ring and push down into junction

for installation. box and hold until secure.

Walker

895 or 896 Series

Floor Box Cover

Apply Solvent Cement

to these Surfaces