![](//vs1.manuzoid.com/store/data-gzf/99740d3492b5ad9044e6d8682240c878/2/001952825.htmlex.zip/bg2.jpg)
Important: the programmer symbols are given as an
indication only; for correct operation of the
programmer, follow the instructions and illustrations
given on these pages.
CONTROL BUTTONS AND SYMBOLS
1. Button used to select minute minder with acoustic
signal
2. Button used to set the cooking duration
3. Button used to set the end-of-cooking time
4. Button used to select manual operation
5. Button used to set or change data
6. Button used to set or change data
AUTO:
when permanently alight, indicates operation
of the oven in automatic mode.
AUTO:
will also blink to confirm end-of-cooking,
prompt further programming or indicate a wrong
selection.
indicates that the oven is in operation and
enabled in manual mode.
indicates operation of the minute minder.
SETTING THE CLOCK, AND SELECTING MANUAL
OPERATION
When the appliance is installed new, or following a
power failure, digits
0:00
and the
AUTO
symbol will
blink in the display. All other functions remain
inhibited.
Press and hold buttons
2
and
3
simultaneously, and set
the clock using buttons
5
and
6.
To operate the oven manually, press button
4
: the
symbol will be displayed.
USING THE MINUTE MINDER WITH ACOUSTIC
SIGNAL
This function is independent of oven operation
• Press button
1
: digits
0:00
are displayed
• Press button
5
or
6
to display the desired cooking time.
Having released the buttons, or a few seconds
afterwards, the actual time and the symbol are
displayed.
The acoustic signal warns that the set time has elapsed.
Press button
1
to silence the acoustic signal.
PROGRAMMING THE COOKING TIME
Press button
2
: digits
0:00
are displayed; set the
desired cooking time with buttons
5
and
6
. After a few
seconds, the actual time is displayed with
AUTO
and
the symbol both permanently alight.
• Set the oven control knob to the temperature
required: the oven will come into operation
immediately.
• Once the cooking time has elapsed, an acoustic
signal indicates that the oven has switched off.
Return the oven control knob to position
“0”
, then
press button
4
to silence the acoustic signal.
Note: the time remaining until end-of-cooking can be
checked or altered at any moment by pressing button
2
.
The end-of-cooking time can also be displayed by
pressing button
3.
USING THE PROGRAMMER
PROGRAMMING DURATION AND END OF
COOKING TIME
• Press button
2
: digits
0:00
are displayed; set the
desired cooking time with buttons
5
and
6
. After a
few seconds, the actual time is displayed with
AUTO
and the symbol both permanently
alight.
• Press button
3
to set the end of cooking time,
which is selected using buttons
5
and
6
. The
symbol will now go out, and reappear again when
the oven comes into operation automatically at the
start of the programmed duration.
• Set the oven control knobs to the temperature and
functions required.
• Once the cooking time has elapsed, an acoustic
signal indicates that the oven has switched off.
Return the oven control knob to position
“0”
, then
press button
4
to silence the acoustic signal.