Page 4
System Operation
Volume
To increase the volume, press . . To decrease the volume, press
Mute To mute the audio on a KPS and KP-3 keypad, press and
together.
To un-mute the audio, press either the or button. From a remote
control, press the MUTE button to mute and un-mute the audio.
Sources To select a source, momentarily press the source’s button. The source
LED illuminates.
Once the source is selected, you can cycle through the programmed
short- press JR by repeatedly pressing the button. Press-and-hold the
source button for about 3 seconds or until the source LED flashes on the
keypad to access additional programmed IR commands for the source.
Stop Commands STOP commands (when programmed) are automatically sent to the
sources
when the first Zone turns on, the last Zone turns off, and when the last
Zone listening to a particular source switches to another source or turns
off.