HanoverOutdoorFurniture
IMPORTANT
Ifyouhaveanyproblemswiththisproduct(missingordamagedparts,assemblyissues,etc.),
PLEASEDONOTRETURNTOTHERETAILER/STORE
fromwhereyoupurchasedtheproduct.
PleasecallourToll‐FreeCustomerServiceHotlineat:1‐800‐416‐3511
Between9:00AMand5:00PMEasternTime,MondaythroughFriday
Orvisitourwebsiteat:www.hanover‐products.com
Toexpediteanyfuturewarrantyclaims,pleaseretaintheInstructionSheet,Warranty
Cardandreceiptforfutureuse.
For additionalon‐linesupportonassembly,troubleshootingandcare&maintenanceofyouroutdoor
furniture,pleasevisitourwebsiteat:www.hanover‐products.com.
6/1/2015(a)
ASSEMBLY INSTRUCTIONS
1
2
Place the table top upside down on a flat, non-abrasive surface. Attach a table leg to the table top by ing two
the table leg
table top
igure
us
1/4"x18 mm bolts and washers as shown in . Guide the bolts through holes in into the
predrilled holes in the . Repeat for other table leg.
F1
Hand tighten only.
Attach the top to a table leg by ing two
the top
igureframe us 1/4"x38 mm bolts and washers as shown in . Guide
the bolts through holes in frame into the pre-drilled holes in the leg. Repeat
for other table leg.
F2
Hand tighten only.
K
I
J
B
FOOT CAP
F
A
K
H
J
3Attach the frame to the legs by using four 1/4"x18 mm bolts and washers as shown in .F3Hand
tighten only.
bottom igure
C
K
J
H
Figure 1
Figure 2
Figure 3
ASSEMBLY INSTRUCTIONS
5
After making any necessary adjustments to the alignment of the panels, use the hex bolt driver to tighten
all bolts. each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to
all bolt joints, we recommend working in a cross corner (X) fashion. Repeat until all bolts are tight.
. Over tightening may strip bolts.
Note:
Do not
over tighten
6
4
Attach the back frame to the legs with bottom frame by using five 1/4"x18 mm bolts and washers as shown
in . .F5Hand tighten onlyigure
Attach the front frame to the legs with bottom frame by using five 1/4"x18 mm bolts and washers as shown
in . .F4Hand tighten onlyigure
K
Figure 4
D
K
K
H
J
K
H
J
K
J
H
K
Figure 5
K
K
H
J
K
J
H
E
*NOTE:PARTSSHOWNONPARTSLISTARENOTTOSCALE
PARTS IDENTIFICATION LIST
PARTS LIST DESCRIPTION ORDER PART # QTY
1
1
A
B
C
D
E
F
G
H
I
J
K
L
1
BOLT COVER
HEX BOLT DRIVER
TABLE LEG
TABLE TOP
HW0105
HW0004
HW0006
2
24
Ø6.5 X 1.0 MM
WASHER
1/4" X 38 MM BOLT HW0344 4
1
BOTTOM FRAME
1/4" X 18 MM BOLT HW0035 18
FRONT FRAME 1
FC0030
FOOT CAP
FACTORY ASSEMBLY
G0003 1
TOUCH-UP PAINT
22
TOP FRAME
BACK FRAME 1
ST1872
ST1873
ST1874
ST1875
ST1876
ST1877
/
