Hanover HAN-CONSOLETBL Operating instructions

Brand: Hanover

Model: HAN-CONSOLETBL

Type: Operating instructions

HanoverOutdoorFurniture

IMPORTANT

Ifyouhaveanyproblemswiththisproduct(missingordamagedparts,assemblyissues,etc.),

PLEASEDONOTRETURNTOTHERETAILER/STORE

fromwhereyoupurchasedtheproduct.

PleasecallourToll‐FreeCustomerServiceHotlineat:1‐800‐416‐3511

Between9:00AMand5:00PMEasternTime,MondaythroughFriday

Orvisitourwebsiteat:www.hanover‐products.com

Toexpediteanyfuturewarrantyclaims,pleaseretaintheInstructionSheet,Warranty

Cardandreceiptforfutureuse.

For additionalon‐linesupportonassembly,troubleshootingandcare&maintenanceofyouroutdoor

furniture,pleasevisitourwebsiteat:www.hanover‐products.com.

6/1/2015(a)

ASSEMBLY INSTRUCTIONS

Place the table top upside down on a flat, non-abrasive surface. Attach a table leg to the table top by ing two

the table leg

table top

igure

1/4"x18 mm bolts and washers as shown in . Guide the bolts through holes in into the

predrilled holes in the . Repeat for other table leg.

Hand tighten only.

Attach the top to a table leg by ing two

the top

igureframe us 1/4"x38 mm bolts and washers as shown in . Guide

the bolts through holes in frame into the pre-drilled holes in the leg. Repeat

for other table leg.

Hand tighten only.

FOOT CAP

3Attach the frame to the legs by using four 1/4"x18 mm bolts and washers as shown in .F3Hand

tighten only.

bottom igure

Figure 1

Figure 2

Figure 3

ASSEMBLY INSTRUCTIONS

After making any necessary adjustments to the alignment of the panels, use the hex bolt driver to tighten

all bolts. each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to

all bolt joints, we recommend working in a cross corner (X) fashion. Repeat until all bolts are tight.

. Over tightening may strip bolts.

Note:

Do not

over tighten

Attach the back frame to the legs with bottom frame by using five 1/4"x18 mm bolts and washers as shown

in . .F5Hand tighten onlyigure

Attach the front frame to the legs with bottom frame by using five 1/4"x18 mm bolts and washers as shown

in . .F4Hand tighten onlyigure

Figure 4

Figure 5

*NOTE:PARTSSHOWNONPARTSLISTARENOTTOSCALE

PARTS IDENTIFICATION LIST

PARTS LIST DESCRIPTION ORDER PART # QTY

BOLT COVER

HEX BOLT DRIVER

TABLE LEG

TABLE TOP

HW0105

HW0004

HW0006

Ø6.5 X 1.0 MM

WASHER

1/4" X 38 MM BOLT HW0344 4

BOTTOM FRAME

1/4" X 18 MM BOLT HW0035 18

FRONT FRAME 1

FC0030

FOOT CAP

FACTORY ASSEMBLY

G0003 1

TOUCH-UP PAINT

TOP FRAME

BACK FRAME 1

ST1872

ST1873

ST1874

ST1875

ST1876

ST1877

Hanover HAN-CONSOLETBL Operating instructions

Hanover HAN-CONSOLETBL Operating instructions

Hanover HAN-CONSOLETBL Operating instructions

Related papers

Other documents