Page is loading ...
VTECH 15750 addiTional HandsET
rEgisTraTion insTruCTions
This additional handset has been designed to operate with a VTech
15750 cordless telephone. Please refer to your VTech 15750 for
instructions on general functionality.
goT EVErYTHing?
The package contains the following items:
VTech 15750 handset
VTech 15750 charger
NiMH rechargeable battery pack
sETTing uP Your VTECH 15750 addiTional HandsET
The position in which you place the VTech 15750 charger could have an
effect on the range and performance of your VTech 15750 handset.
Plug the power cable into the charger base.
Plug the other end into a mains power wall socket.
•
•
•
1.
2.
Version A
FOR MORE INFORMATION CALL:
TECHELP ON 1300 369 193 OR
EMAIL: TCPSUPPORT_AU@VTECH.COM
Note: Ensure power cord is fed through slot on base so unit sits
ush with the desk.
Mains power wall
socket
1
2
Mains power cable
1
3. Plug the battery connector securely into the socket inside the
handset battery compartment. Insert the supplied battery as
indicated.
4. Align the cover at against the battery compartment, then slide it
upwards until it clicks into place.
rEgisTEring a VTECH 15750 addiTional HandsET
The display of an unregistered VTech 15750 handset shows
To register HS, see manual.. The additional handset must be
registered to the base station before use. To register a cordless
handset to your VTech 15750 telephone system, follow the process
as detailed below.
Register a VTech 15750 additional handset to a VTech 15750 base
station:
Before you begin registration, make sure the handset is out of the
base station or charger and shows To register HS, see manual.
Put the handset on the base cradle. The handset shows
Registering... Please wait.
1.
2.
If you have any problems with your phone, refer to the Help section of
your VTech 15750 User Guide.
32
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
Note: The display of your handset may go blank for a short time when
placing back on charge. This is the normal operation of your handset.
3
5. Charge the handset by placing it face forward in the telephone
base or charger. The CHARGE light on the handset is on during
charging.
4
Note: If the handset registration is successful, you will hear a
conrmation tone. The handset will automatically be allocated the
next available handset number. This handset number will be shown
in the handset display in standby mode. If the handset registration
is unsuccessful, repeat the registration steps above.
/